- 您現在的位置：買賣IC網 > PDF目錄69019 > MB89P585BWPFV 8-BIT, OTPROM, 12.5 MHz, MICROCONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | MB89P585BWPFV |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, OTPROM, 12.5 MHz, MICROCONTROLLER, PQFP64 |
| 封裝： | 0.50 MM PITCH, PLASTIC, LQFP-64 |
| 文件頁數： | 3/37頁 |
| 文件大小： | 428K |
| 代理商： | MB89P585BWPFV |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
MB89580B/580BW series
11
s HANDLING DEVICES
1.
Preventing Latchup
Latchup may occur on CMOS ICs if voltage higher than Vcc or lower than Vss is applied to input or output pins
other than the medium- and high-voltage pins or if voltage higher than the rating is applied between Vcc and Vss.
When latchup occurs, power supply current increases rapidly and might thermally damage elements. When
using, take great care not to exceed the absolute maximum ratings.
Also take care to prevent the analog input from exceeding the digital power supply (Vcc) when the power supply
to the analog power system is turned on and off.
2.
Treatment of Unused Input Pins
Leaving unused input pins open could cause malfunctions and latchup leading to permanent damage to the
pins. These unused pins should be connected to a pullup or pulldown resistance of at least 2 k
between the
pin and the power supply.
Unused I/O pins should be placed in output state to leave it open or pins that are in input state should be handled
the same as unused input pins.
3.
Power Supply Voltage Fluctuations
Although Vcc power supply voltage is assured to operate within the rated range, a rapid fluctuation of the voltage
could cause malfunctions even if it occurs within the rated range. Stabilizing voltage supplied to the IC is therefore
important. As stabilization guidelines, it is recommended to control power so that Vcc ripple fluctuations (P-P
value) will be less than 10% of the standard VCC value at the commercial frequency (50 to 60 Hz) and the transient
fluctuation rate will be less than 0.1 V/ms at the time of a momentary fluctuation such as when power is switched.
相關PDF資料 |
PDF描述 |
|---|---|
| MB89583BWPFV | 8-BIT, MROM, 12.5 MHz, MICROCONTROLLER, PQFP64 |
| MB89P589BPFM | 8-BIT, OTPROM, 12.5 MHz, MICROCONTROLLER, PQFP64 |
| MB89P629P-SH | 8-BIT, OTPROM, 10 MHz, MICROCONTROLLER, PDIP64 |
| MB89P665P-SH | 8-BIT, OTPROM, 10 MHz, MICROCONTROLLER, PDIP64 |
| MB89663RP-SH | 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PDIP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB89P589B | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontrollers |
| MB89P589BPFM | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontrollers |
| MB89P595B | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontrollers |
| MB89P595BPFV | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontrollers |
| MB89P595BW | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。