- 您現在的位置：買賣IC網 > PDF目錄377937 > MBM29DL164BE-90 (Fujitsu Limited) 16M (2M X 8/1M X 16) BIT Dual Operation PDF資料下載
參數資料
| 型號： | MBM29DL164BE-90 |
| 廠商： | Fujitsu Limited |
| 英文描述： | 16M (2M X 8/1M X 16) BIT Dual Operation |
| 中文描述： | 16米（2米x 8/1M × 16）位雙操作 |
| 文件頁數： | 21/75頁 |
| 文件大?。?/td> | 1089K |
| 代理商： | MBM29DL164BE-90 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁
MBM29DL16XTE/BE
-70/90/12
21
Standby Mode
There are two ways to implement the standby mode on the MBM29DL16XTE/BE devices, one using both the
CE and RESET pins; the other via the RESET pin only.
When using both pins, a CMOS standby mode is achieved with CE and RESET inputs both held at V
CC
± 0.3 V.
Under this condition the current consumed is less than 5
μ
A max. During Embedded Algorithm operation, V
CC
active current (I
CC2
) is required even CE = “H”. The device can be read with standard access time (t
CE
) from either
of these standby modes.
When using the RESET pin only, a CMOS standby mode is achieved with RESET input held at V
SS
± 0.3 V (CE
= “H” or “L”). Under this condition the current is consumed is less than 5
μ
A max. Once the RESET pin is taken
high, the device requires t
RH
of wake up time before outputs are valid for read access.
In the standby mode the outputs are in the high impedance state, independent of the OE input.
Automatic Sleep Mode
There is a function called automatic sleep mode to restrain power consumption during read-out of
MBM29DL16XTE/BE data. This mode can be used effectively with an application requested low power
consumption such as handy terminals.
To activate this mode, MBM29DL16XTE/BE automatically switch themselves to low power mode when
MBM29DL16XTE/BE addresses remain stably during access fine of 150 ns. It is not necessary to control CE,
WE, and OE on the mode. Under the mode, the current consumed is typically 1
μ
A (CMOS Level).
During simultaneous operation, V
CC
active current (I
CC2
) is required.
Since the data are latched during this mode, the data are read-out continuously. If the addresses are changed,
the mode is canceled automatically and MBM29DL16XTE/BE read-out the data for changed addresses.
Output Disable
With the OE input at a logic high level (V
IH
), output from the devices are disabled. This will cause the output pins
to be in a high impedance state.
Autoselect
The autoselect mode allows the reading out of a binary code from the devices and will identify its manufacturer
and type. This mode is intended for use by programming equipment for the purpose of automatically matching
the devices to be programmed with its corresponding programming algorithm. This mode is functional over the
entire temperature range of the devices.
To activate this mode, the programming equipment must force V
ID
(11.5 V to 12.5 V) on address pin A
9
. Two
identifier bytes may then be sequenced from the devices outputs by toggling address A
0
from V
IL
to V
IH
. All
addresses are DON’T CARES except A
0
, A
1
, and A
6
(A
-1
). (See Tables 3 and 4.)
The manufacturer and device codes may also be read via the command register, for instances when the
MBM29DL16XTE/BE are erased or programmed in a system without access to high voltage on the A
9
pin. The
command sequence is illustrated in Table 12. (Refer to Autoselect Command section.)
相關PDF資料 |
PDF描述 |
|---|---|
| MBM29DL164BE70PBT | 16M (2M X 8/1M X 16) BIT Dual Operation |
| MBM29DL164BE70PFTN | 16M (2M x 8/1M x 16) BIT Dual Operation |
| MBM29DL161TD | 16M (2M x 8/1M x 16) BIT Dual Operation |
| MBM29DL161TE70TR | 16M (2M X 8/1M X 16) BIT Dual Operation |
| MBM29DL162BE70PBT | 16M (2M X 8/1M X 16) BIT Dual Operation |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MBM29DL164BE-90PBT | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:FLASH MEMORY CMOS 16M (2M X 8/1M X 16) BIT Dual Operation |
| MBM29DL164BE-90TN | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:FLASH MEMORY CMOS 16M (2M X 8/1M X 16) BIT Dual Operation |
| MBM29DL164BE-90TR | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:FLASH MEMORY CMOS 16M (2M X 8/1M X 16) BIT Dual Operation |
| MBM29DL164TD | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16M (2M x 8/1M x 16) BIT Dual Operation |
| MBM29DL164TD-70PBT | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:FLASH MEMORY CMOS 16M (2M X 8/1M X 16) BIT Dual Operation |
發布緊急采購，3分鐘左右您將得到回復。