- 您現在的位置：買賣IC網 > PDF目錄67964 > MC-80C32E-30/883 (ATMEL CORP) 8-BIT, 30 MHz, MICROCONTROLLER, CDIP40 PDF資料下載
參數資料
| 型號： | MC-80C32E-30/883 |
| 廠商： | ATMEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, 30 MHz, MICROCONTROLLER, CDIP40 |
| 封裝： | SIDE BRAZED, DIP-40 |
| 文件頁數： | 18/20頁 |
| 文件大小： | 239K |
| 代理商： | MC-80C32E-30/883 |
7
80C32E
Rev. K – 21-Aug-01
Idle mode
An instruction that sets PCON.0 causes that to be the last instruction executed before
going into the Idle mode. In the Idle mode, the internal clock signal is gated off to the
CPU, but not to the interrupt, Timer, and Serial Port functions. The CPU status is pre-
served in its entirely: the Stack Pointer, Program Counter, Program Status Word,
Accumulator, RAM and all other registers maintain their data during Idle. The port pins
hold the logical states they had at the time Idle was activated. ALE and PSEN hold at
logic high levels.
There are two ways to terminate the Idle. Activation of any enabled interrupt will cause
PCON.0 to be cleared by hardware, terminating the Idle mode. The interrupt will be ser-
viced, and following RETI the next instruction to be executed will be the one following
the instruction that put the device into idle.
The flag bits GF0 and GF1 can be used to give and indication if an interrupt occurred
during normal operation or during an Idle. For example, an instruction that activates Idle
can also set one or both flag bits. When Idle is terminated by an interrupt, the interrupt
service routine can examine the flag bits.
The over way of terminating the Idle mode is with a hardware reset. Since the clock
oscillator is still running, the hardware reset needs to be held active for only two
machine cycles (24 oscillator periods) to complete the reset.
相關PDF資料 |
PDF描述 |
|---|---|
| MJ-80C32E-30/883 | 8-BIT, 30 MHz, MICROCONTROLLER, PQCC44 |
| MC3S12HZ256J3CAA | 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP80 |
| MC3S12HZ256J3MAL | 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP112 |
| MC9S12HZ256J3MAL | 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP112 |
| MC9S12HZ256J3VAL | 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP112 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC-80C32E-30-E | 制造商:AIMTEC 制造商全稱:AIMTEC 功能描述:Rad. Tolerant 8-bit ROMless Microcontroller |
| MC80D21000G | 制造商:COR 功能描述:RN |
| MC80F0104 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS |
| MC80F0104B | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS |
| MC80F0104D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-BIT SINGLE-CHIP MICROCONTROLLERS |
發布緊急采購，3分鐘左右您將得到回復。