參數資料
型號： MC13109A
廠商： Motorola, Inc.
英文描述： UNIVERSAL CORDLESS TELEPHONE SUBSYSTEM IC
中文描述： 通用無繩電話子系統集成電路
文件頁數： 10/28頁
文件大?。?/td> 1307K
代理商： MC13109A
MC13109A
10
MOTOROLA RF/IF DEVICE DATA
ELECTRICAL CHARACTERISTICS
(continued)
Splatter Amplifier
The Splatter Amplifier is an inverting rail–to–rail output
operational amplifier with the non–inverting input terminal
connected to the internal VB half supply reference. External
resistors and capacitors can be connected to set the gain and
frequency response. The “Spl Amp In” input is ac coupled.
(Test Conditions: VCC = 2.6 V, TA = 25
°
C, fin = 1.0 kHz, External resistors Set for Gain of 1.)
Characteristic
Condition
Input
Pin
Measure
Pin
Symbol
Min
Typ
Max
Unit
Open Loop Gain
–
Spl Amp
In
Tx Out
AVOL
–
60
–
dB
Gain Bandwidth
–
Spl Amp
In
Tx Out
GBW
–
100
–
kHz
Maximum Output Swing
RL = 10 k
Spl Amp
In
Tx Out
VOmax
–
VCC – 0.3
–
Vpp
Tx Audio Path Recommendation
The recommended configuration for the Tx Audio path
includes setting the Microphone Amplifier gain to 16 dB using
the external gain setting resistors and setting the Splatter
Amplifier gain to 9.0 dB using the external gain setting
resistors.
PLL Voltage Regulator
The PLL supply voltage is regulated to a nominal of 2.2 V.
The “V
CC
Audio” pin is the supply voltage for the internal
voltage regulator. The “PLL Vref ” pin is the 2.2 V regulated
output voltage. Two capacitors with 10
μ
F and 0.01
μ
F values
must be connected to the “PLL Vref ” pin to filter and stabilize
this regulated voltage. The voltage regulator provides power
for the 2nd LO, Rx and Tx PLL’s, and MPU Interface. The
voltage regulator can also be used to provide a regulated
supply voltage for external IC’s. Rx and Tx PLL loop
performance are independent of the power supply voltage
when the voltage regulator is used. The voltage regulator
requires about 200 mV of “headroom”. When the power
supply decreases to within about 200 mV of the output
voltage, the regulator will go out of regulation but the output
voltage will not turn off. Instead, the output voltage will
maintain about a 200 mV delta to the power supply voltage as
the power supply voltage continues to decrease. The “PLL
Vref” pin can be connected to “V
CC
Audio” by the external
wiring if voltage higher than 2.2 V is required. But it should
not be connected to other supply except “V
CC
Audio”. The
voltage regulator is “on” in the Active and Rx modes. In the
Standby and Inactive modes, the voltage regulator is turned
off to reduce current drain and the “PLL Vref” pin is internally
connected to “V
CC
Audio” (i.e., the supply voltage is
maintained but is now unregulated).
(Test Conditions: VCC = 2.6 V, TA = 25
°
C.)
Characteristic
Condition
Input
Pin
Measure
Pin
Symbol
Min
Typ
Max
Unit
Output Voltge Level
VCC = 2.6 V,
OL= 0 mA
–
VCC PLL
Vout
–
2.2
–
V
Line Regulation
IL = 0 mA, VCC = 2.6 to
5.5 V
VCC
VCC PLL
Regline
–
3.66
40
mV
Load Regulation
VCC = 2.6 V, IL = 0 to
1.0 mA
VCC
VCC PLL
Regload
–40
–2.28
–
mV
相關PDF資料
PDF描述
MC13109AFB UNIVERSAL CORDLESS TELEPHONE SUBSYSTEM IC
MC13109AFTA UNIVERSAL CORDLESS TELEPHONE SUBSYSTEM IC
MC13110A Narrowband FM IF Receiver(窄頻帶FM IF 接收器)
MC13111A Narrowband FM IF Receiver(窄頻帶FM IF 接收器)
MC13111BFTA UNIVERSAL NARROWBAND FM RECEIVER INTEGRATED CIRCUIT
相關代理商/技術參數
參數描述
MC13109AFB 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:UNIVERSAL CORDLESS TELEPHONE SUBSYSTEM IC
MC13109AFTA 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:UNIVERSAL CORDLESS TELEPHONE SUBSYSTEM IC
MC13109FB 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Universal Cordless Telephone Subsystem IC
MC13109FTA 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Universal Cordless Telephone Subsystem IC
MC1310DIN 功能描述:電源線濾波器 Filter 500V 10A RoHS:否 制造商:EPCOS 電壓額定值:277 VAC 電流額定值:100 A 安裝風格:Chassis 端接類型:Screw
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*