參數資料
型號: MC13224VR2
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: SPECIALTY MICROPROCESSOR CIRCUIT, PBGA99
封裝: 9.50 X 9.50 MM, 1.20 MM HEIGHT, ROHS COMPLIANT, LGA-99
文件頁數: 3/54頁
文件大?。?/td> 490K
代理商: MC13224VR2
MC1322x Technical Data, Rev. 1.3
Freescale Semiconductor
11
impedance matching is also onboard. This combination allows for a very small footprint and a very low
cost RF solution.
The MC1322x also provides a secondary set of complementary PA outputs that can be used with external
RF circuitry such as a additional PA for higher TX power to the antenna. The single-ended port continues
as the receive input for this circuit configuration.
The receiver demodulator includes a module called the Differential Chip Detector which has two modes
of operation:
Non-coherent Detection (NCD) with automatic frequency control (AFC)
Non-coherent Differential Chip Detection (DCD) without AFC
The IEEE 802.15.4 standard allows a maximum clock drift of ±40 ppm (which equals ±80 ppm
station-to-station). The MC1322x 802.15.4 demodulator includes two different methods of operating in
the presence of such large frequency errors:
NCD Mode
Provides an increased ~3.5 dB of sensitivity. However, the addition of the AFC
increases the demodulator current drain about 3 mA.
DCD Mode
Default receive mode at lower current.
For longer range applications where external amplification may be desired (LNA and/or PA), additional
ports are provided for secondary complementary PA outputs. These can be used as a separate PA interface
while the single-ended port through the balun is used as an input only. Also, four control pins and a
regulated 20mA voltage source are provided to control external components and supply power to the PA
outputs.
The RF Interface functionality can be summarized as follows:
Programmable output power — 0 dBm nominal output power, programmable from -30 to +4 dBm
Receive sensitivity (at 1% PER, 20-byte packet) -
— < -96 dBm (typical) DCD receive (well above IEEE 802.15.4 specification of -85 dBm)
— < -100 dBm (typical) NCD receive (higher current)
Single-ended 50-
Ω antenna port — Uses integrated transmit/receive (T/R) switch, LNA, and
onboard balun. Impedance matching onboard.
Maximum flexibility — The optional single-ended port becomes RF input only and a separate set
of full differential PA outputs are provided. Separate input and outputs allow for a variety of RF
configurations including external LNA and PA for increased range
Four control signals for external RF components such as a LNA or PA
Regulated voltage source for PA biasing and powering external components
3.1.2
Modem
The modem supports the full requirement of the IEEE 802.15.4 Standard to transmit and receive data
packets. In additional, the mechanism is present to measure received signal level to provide CCA, ED, and
LQI as required by the 802.15.4 Standard.
相關PDF資料
PDF描述
MC13226V SPECIALTY MICROPROCESSOR CIRCUIT, PBGA99
MC13226VR2 SPECIALTY MICROPROCESSOR CIRCUIT, PBGA99
MC13224V SPECIALTY MICROPROCESSOR CIRCUIT, PBGA99
MC141556P1 UNIVERSAL SERIAL BUS CONTROLLER, PDIP28
MC141556P1 UNIVERSAL SERIAL BUS CONTROLLER, PDIP28
相關代理商/技術參數
參數描述
MC13224VR2 制造商:Freescale Semiconductor 功能描述:IC 32BIT MCU ARM7 26MHZ LGA-99
MC13224VR2-CUT TAPE 制造商:Freescale 功能描述:MC13224 Series 2.4 GHz PIP 250 KBps Surface Mount RF Transceiver - LGA-99
MC13226V 功能描述:射頻收發器 Kaibab PRO ROM SE 1.0 RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray
MC13226VR2 功能描述:射頻收發器 Kaibab PRO ROM SE 1.0 RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray
MC1322X 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Advanced ZigBee?- Compliant Platform-in-Package (PiP) for the 2.4 GHz IEEE? 802.15.4 Standard