參數資料
型號: MC68HC05C9A
廠商: Motorola, Inc.
元件分類: 8位微控制器
英文描述: 8-Bit Microcontroller(8位微控制器)
中文描述: 8位微控制器(8位微控制器)
文件頁數: 76/160頁
文件大?。?/td> 783K
代理商: MC68HC05C9A
L
G
R
Serial Communications Interface (SCI)
General Release Specification
MC68HC05C9A
Rev. 4.0
76
Serial Communications Interface (SCI)
MOTOROLA
9.9 Idle Line Wakeup
In idle line wakeup mode, a dormant receiver wakes up as soon as the
RDI line becomes idle. Idle is defined as a continuous logic high level on
the RDI line for 10 (or 11) full bit times. Systems using this type of
wakeup must provide at least one character time of idle between
messages to wake up sleeping receivers, but must not allow any idle
time between characters within a message.
9.10 Address Mark Wakeup
In address mark wakeup, the most significant bit (MSB) in a character is
used to indicate whether it is an address (logic one) or data (logic zero)
character. Sleeping receivers will wake up whenever an address
character is received. Systems using this method for wakeup would set
the MSB of the first character of each message and leave it clear for all
other characters in the message. Idle periods may be present within
messages and no idle time is required between messages for this
wakeup method.
9.11 Receive Data In (RDI)
Receive data is the serial data that is applied through the input line and
the SCI to the internal bus. The receiver circuitry clocks the input at a
rate equal to 16 times the baud rate. This time is referred to as the RT
rate in
Figure 9-4
and as the receiver clock in
Figure 9-6
.
The receiver clock generator is controlled by the baud rate register;
however, the SCI is synchronized by the start bit, independent of the
transmitter.
Once a valid start bit is detected, the start bit, each data bit, and the stop
bit are sampled three times at RT intervals 8 RT, 9 RT, and 10 RT (1 RT
is the position where the bit is expected to start), as shown in
Figure 9-
5
. The value of the bit is determined by voting logic which takes the value
of the majority of the samples. A noise flag is set when all three samples
on a valid start bit or data bit or the stop bit do not agree.
相關PDF資料
PDF描述
MC68HCL05C9A 8-Bit Microcontroller(8位微控制器)
MC68HSC05C9A 8-Bit Microcontroller(8位微控制器)
MC68HC05F2 8-Bit Microcontroller Units (MCU).(8位微控制器)
MC68HC05F6 8-Bit Microcontroller Units (MCU).(8位微控制器)
MC68HC05K3 8-Bit Microcontroller Units (MCU).(8位微控制器)
相關代理商/技術參數
參數描述
MC68HC05C9AB 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05C9AFB 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05C9AFN 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05C9AMB 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05C9AMFB 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers