MSCAN08 Controller (MSCAN08)
MC68HC08AZ32A Data Sheet, Rev. 2
136
Freescale Semiconductor
The following registers enter and stay in their hard reset state:
CMCR0, CRFLG, CRIER, CTFLG, and CTCR.
The registers CMCR1, CBTR0, CBTR1, CIDAC, CIDAR0–CIDAR3, and CIDMR0–CIDMR3 can only
be written by the CPU when the MSCAN08 is in soft reset state. The values of the error counters are
not affected by soft reset.
When this bit is cleared by the CPU, the MSCAN08 tries to synchronize to the CAN bus. If the
MSCAN08 is not in bus-off state, it will be synchronized after 11 recessive bits on the bus; if the
MSCAN08 is in bus-off state, it continues to wait for 128 occurrences of 11 recessive bits.
Clearing SFTRES and writing to other bits in CMCR0 must be in separate instructions.
1 = MSCAN08 in soft reset state
0 = Normal operation
11.13.2 MSCAN08 Module Control Register 1
LOOPB — Loop Back Self-Test Mode
When this bit is set, the MSCAN08 performs an internal loop back which can be used for self-test
operation: the bit stream output of the transmitter is fed back to the receiver internally. The CANRX
input pin is ignored and the CANTX output goes to the recessive state (logic 1). The MSCAN08
behaves as it does normally when transmitting and treats its own transmitted message as a message
received from a remote node. In this state the MSCAN08 ignores the bit sent during the ACK slot of
the CAN frame Acknowledge field to insure proper reception of its own message. Both transmit and
receive interrupts are generated.
1 = Activate loop back self-test mode
0 = Normal operation
WUPM — Wakeup Mode
This flag defines whether the integrated low-pass filter is applied to protect the MSCAN08 from
1 = MSCAN08 will wakeup the CPU only in cases of a dominant pulse on the bus which has a length
of at least twup.
0 = MSCAN08 will wakeup the CPU after any recessive-to-dominant edge on the CAN bus.
CLKSRC — Clock Source
This flag defines which clock source the MSCAN08 module is driven from (see
11.10 Clock System).
NOTE
The CMCR1 register can be written only if the SFTRES bit in the MSCAN08
module control register is set
Address:
$0501
Bit 7
654321
Bit 0
Read:
00000
LOOPB
WUPM
CLKSRC
Write:
Reset:
00000000
= Unimplemented
Figure 11-17. Module Control Register (CMCR1)