參數資料
型號： MC68HC11A1CP2
廠商： ABILIS SYSTEMS
元件分類： 微控制器/微處理器
英文描述： 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PDIP48
封裝： PLASTIC, DIP-48
文件頁數： 97/158頁
文件大小： 3803K
代理商： MC68HC11A1CP2
PARALLEL I/O
MOTOROLA
TECHNICAL DATA
4-5
4
STAF — Strobe A Interrupt Status Flag
This bit is set when a selected edge occurs on strobe A. Clearing it depends on the
state of HNDS and OIN bits. In simple strobed mode or in full input handshake mode,
STAF is cleared by reading the PIOC register with STAF set followed by reading the
PORTCL register. In output handshake, STAF is cleared by reading the PIOC register
with STAF set followed by writing to the PORTCL register.
STAI — Strobe A Interrupt Enable Mask
When the I bit in the condition code register is clear and STAI is set, STAF (when set)
will request an interrupt.
CWOM — Port C Wire-OR Mode
CWOM affects all eight port C pins together
0 = Port C outputs are normal CMOS outputs
1 = Port C outputs act as open-drain outputs
HNDS — Handshake Mode
When clear, strobe A acts as a simple input strobe to latch data into PORTCL, and
strobe B acts as a simple output strobe which pulses after a write to port B. When set,
a handshake protocol involving port C, STRA, and STRB is selected (see the definition
for the OIN bit).
0 = Simple strobe mode
1 = Full input or output handshake mode
OIN — Output or Input Handshaking
This bit has no meaning when HNDS = 0.
0 = Input handshake
1 = Output handshake
PLS — Pulse/Interlocked Handshake Operation
This bit has no meaning if HNDS = 0. When interlocked handshake operation is se-
lected, strobe B, once activated, stays active until the selected edge of strobe A is de-
tected. When pulsed handshake operation is selected, strobe B is pulsed for two E
cycles.
0 = Interlocked handshake select
1 = Pulsed handshake selected
EGA — Active Edge for Strobe A
0 = Falling edge of STRA is selected. When output handshake is selected, port C
lines obey the data direction register while STRA is low, but port C is forced to
output when STRA is high.
1 = Rising edge of STRA is selected. When output handshake is selected, port C
lines obey the data direction register while STRA is high, but port C is forced to
output when STRA is low.
INVB — Invert Strobe B
0 = Active level is logic zero
1 = Active level is logic one
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料
PDF描述
MC68HC11A1CFU2 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQFP64
MC68HC11A8BMP2 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PDIP48
MC68HC11A0CFU2 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQFP64
MC68HC11A0CP2 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PDIP48
MC68HC11A8BCFN2 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQCC52
相關代理商/技術參數
參數描述
MC68HC11A1CP3 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS Single-Chip Microcontroller
MC68HC11A1FN 制造商: 功能描述:
MC68HC11A1MFN 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:8-Bit Microcontrollers
MC68HC11A1MFN2 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS Single-Chip Microcontroller
MC68HC11A1MFNE 功能描述:8位微控制器 -MCU 8B MCU 256RAM A/D EE RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*