參數資料
型號: MC68HCP11A1FN
廠商: MOTOROLA INC
元件分類: 微控制器/微處理器
英文描述: 8-Bit Microcontrollers
中文描述: 8-BIT, EEPROM, MICROCONTROLLER, PQCC52
封裝: PLASTIC, LCC-52
文件頁數: 17/45頁
文件大小: 286K
代理商: MC68HCP11A1FN
MC68HC11A8
MC68HC11A8TS/D
MOTOROLA
17
4 Electrically
Erasable
Programmable
Read-Only
Memory
(EEPROM)
The 512 bytes of EEPROM in the MC68HC11A8 are located at $B600 through $B7FF. The EEON bit
in CONFIG controls the presence or absence of the EEPROM in the memory map. When EEON = 1
(erased state), the EEPROM is enabled. When EEON = 0, the EEPROM is disabled and out of the
memory map. EEON is reset to the value last programmed into CONFIG. An on-chip charge pump de-
velops the high voltage required for programming and erasing. When the E clock is less than 1 MHz,
select an internal clock. This drives the EEPROM charge pump by writing a one to the CSEL bit in the
OPTION register.
The PPROG register controls the programming and erasing of the EEPROM. To erase the EEPROM,
complete the following steps using the PPROG register:
1.
2.
Write to PPROG with the ERASE, EELAT, and appropriate BYTE and ROW bits set.
Write to the appropriate EEPROM address with any data. Row erase only requires a write to
any location in the row. Bulk erase is accomplished by writing to any location in the array.
Write to PPROG with ERASE, EELAT, EEPGM, and the appropriate BYTE and ROW bits set.
Delay for 10 ms or more, as appropriate.
Clear the EEPGM bit in PPROG to turn off the high voltage.
Clear the PPROG register to reconfigure the EEPROM address and data buses for normal op-
eration.
To program the EEPROM, complete the following steps using the PPROG register:
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
Write to PPROG with the EELAT bit set.
Write data to the desired address.
Write to PPROG with the EELAT and EEPGM bits set.
Delay for 10 ms or more, as appropriate.
Clear the EEPGM bit in PPROG to turn off the high voltage.
Clear the PPROG register to reconfigure the EEPROM address and data buses for normal op-
eration.
ODD — Program Odd Rows in Half of EEPROM (TEST)
EVEN — Program Even Rows in Half of EEPROM (TEST)
BYTE — Byte/Other EEPROM Erase Mode
The BYTE bit overrides the ROW bit.
0 = Row or bulk erase mode is used
1 = Erase only one byte of EEPROM
ROW — Row/All EEPROM Erase Mode
The ROW bit is only valid when BYTE = 0.
0 = All 512 bytes of EEPROM are erased
1 = Erase only one 16-byte row of EEPROM
PPROG
— EEPROM Programming Control
$103B
Bit 7
ODD
0
6
5
0
0
4
3
2
1
Bit 0
EEPGM
0
EVEN
0
BYTE
0
ROW
0
ERASE
0
EELAT
0
RESET:
BYTE
0
0
1
1
ROW
0
1
0
1
Action
Bulk Erase (All 512 Bytes)
Row Erase (16 Bytes)
Byte Erase
Byte Erase
相關PDF資料
PDF描述
MC68HSC705C8ACFS M68HC05 MICROCONTROLLERS
MC705C8ACFNR2 M68HC05 MICROCONTROLLERS
MC68HSC705C8ACS M68HC05 MICROCONTROLLERS
MC68HSC705C8A HCMOS Microcontroller Unit
MC68HSC705C8ACB M68HC05 MICROCONTROLLERS
相關代理商/技術參數
參數描述
MC68HCP11E0CP2 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC68HCP11E0FN 功能描述:MICROCONTROLLER MCU 8ADC 3MHC RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:HC11 標準包裝:250 系列:56F8xxx 核心處理器:56800E 芯體尺寸:16-位 速度:60MHz 連通性:CAN,SCI,SPI 外圍設備:POR,PWM,溫度傳感器,WDT 輸入/輸出數:21 程序存儲器容量:40KB(20K x 16) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:6K x 16 電壓 - 電源 (Vcc/Vdd):2.25 V ~ 3.6 V 數據轉換器:A/D 6x12b 振蕩器型:內部 工作溫度:-40°C ~ 125°C 封裝/外殼:48-LQFP 包裝:托盤 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323
MC68HCP11E0FNE 功能描述:8位微控制器 -MCU 8B MCU 512RAM COP A/D RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC68HCP11E1CFNE2 功能描述:8位微控制器 -MCU 8B MCU 512 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
MC68HCP11E1CFNE3 功能描述:8位微控制器 -MCU 8B MCU 512 BYTES RAM RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT