- 您現在的位置：買賣IC網 > PDF目錄4044 > MC7447AHX1000LB (Freescale Semiconductor)IC MPU RISC 32BIT 360-FCCBGA PDF資料下載
參數資料
| 型號： | MC7447AHX1000LB |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 32/56頁 |
| 文件大小： | 0K |
| 描述： | IC MPU RISC 32BIT 360-FCCBGA |
| 標準包裝： | 44 |
| 系列： | MPC74xx |
| 處理器類型： | 32-位 MPC74xx PowerPC |
| 速度： | 1.0GHz |
| 電壓： | 1.3V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 360-BCBGA，F(xiàn)CCBGA |
| 供應商設備封裝： | 360-FCCBGA（25x25） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁
MPC7447A RISC Microprocessor Hardware Specifications, Rev. 5
38
Freescale Semiconductor
System Design Information
These capacitors should have a value of 0.01 or 0.1 F. Only ceramic surface mount technology (SMT)
capacitors should be used to minimize lead inductance. Orientations where connections are made along
the length of the part, such as 0204, are preferable but not mandatory. Consistent with the
recommendations of Dr. Howard Johnson in High Speed Digital Design: A Handbook of Black Magic
(Prentice Hall, 1993) and contrary to previous recommendations for decoupling Freescale
microprocessors, multiple small capacitors of equal value are recommended over using multiple values of
capacitance.
In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB,
feeding the VDD and OVDD planes, to enable quick recharging of the smaller chip capacitors. These bulk
capacitors should have a low equivalent series resistance (ESR) rating to ensure the quick response time
necessary. They should also be connected to the power and ground planes through two vias to minimize
inductance. Suggested bulk capacitors are: 100–330 F (AVX TPS tantalum or Sanyo OSCON).
9.4
Connection Recommendations
To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal
level. Unless otherwise noted, unused active-low inputs should be tied to OVDD, and unused active-high
inputs should be connected to GND. All NC (no connect) signals must remain unconnected.
Power and ground connections must be made to all external VDD, OVDD, and GND pins in the
MPC7447A. For backward compatibility with the MPC7447, MPC7445, and MP7441, or for migrating a
system originally designed for one of these devices to the MPC7447A, the new power and ground signals
(formerly NC, see Table 12) may be left unconnected. There is no performance degradation associated
with leaving these pins unconnected. However, future devices may require these additional power and
ground signals to be connected to achieve maximum performance, and it is recommended that new designs
include the additional connections to facilitate future upgrades. See also Section 7, “Pinout Listings,” for
additional information.
9.5
Output Buffer DC Impedance
The MPC7447A processor bus drivers are characterized over process, voltage, and temperature. To
measure Z0, an external resistor is connected from the chip pad to OVDD or GND. The value of each
resistor is varied until the pad voltage is OVDD/2. Figure 18 shows the driver impedance measurement.
The output impedance is the average of two components—the resistances of the pull-up and pull-down
devices. When data is held low, SW2 is closed (SW1 is open), and RN is trimmed until the voltage at the
pad equals OVDD/2. RN then becomes the resistance of the pull-down devices. When data is held high,
SW1 is closed (SW2 is open), and RP is trimmed until the voltage at the pad equals OVDD/2. RP then
becomes the resistance of the pull-up devices. RP and RN are designed to be close to each other in value.
Then, Z0 = (RP + RN)/2.
相關PDF資料 |
PDF描述 |
|---|---|
| MPC8535BVTATHA | MCU PWRQUICC II 1250MHZ 783-PBGA |
| XC4036XL-3HQ304C | IC FPGA C-TEMP 3.3V 3SPD 304HQFP |
| 65801-123LF | CLINCHER RECEPTACLE ASSY TIN |
| 65801-121LF | CLINCHER RECEPTACLE ASSY TIN |
| MPC8543EPXANGB | MPU POWERQUICC III 783-PBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC7447AHX1000NB | 功能描述:微處理器 - MPU APOLO7PM RV1.1 1.1V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MC7447AHX1000NBR | 制造商:Freescale Semiconductor 功能描述:MPU MPC74XX RISC 32BIT 0.13UM 1GHZ 1.8V/2.5V 360FCCBGA - Tape and Reel |
| MC7447AHX1000PC | 制造商:Freescale Semiconductor 功能描述:MPU MPC74XX RISC 32BIT 0.13UM 1GHZ 1.8V/2.5V 360FCCBGA - Bulk |
| MC7447AHX1167NB | 功能描述:微處理器 - MPU APOLO7PM RV1.1 1.1V 105C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MC7447AHX1167NB | 制造商:Freescale Semiconductor 功能描述:IC 32-BIT MPU 1.167GHZ 360-FCCBGA |
發布緊急采購，3分鐘左右您將得到回復。