- 您現在的位置：買賣IC網 > PDF目錄1953 > MCP2140-I/P (Microchip Technology)IC IRDA CONTROLLER DTE/DCE 18DIP PDF資料下載
參數資料
| 型號： | MCP2140-I/P |
| 廠商： | Microchip Technology |
| 文件頁數： | 56/58頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC IRDA CONTROLLER DTE/DCE 18DIP |
| 產品培訓模塊： | IrDA® Standard Protocol |
| 標準包裝： | 25 |
| 控制器類型： | IRDA 標準協議?？刂破?br> |
| 接口： | UART |
| 電源電壓： | 3 V ~ 5.5 V |
| 電流 - 電源： | 2.2mA |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 18-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 18-PDIP |
| 包裝： | 管件 |
| 產品目錄頁面： | 685 (CN2011-ZH PDF) |
| 配用： | MCP2140DM-TMPSNS-ND - BOARD DEMO FOR MCP2140 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁
2003 Microchip Technology Inc.
Preliminary
DS21790A-page 7
MCP2140
2.0
DEVICE OPERATION
The MCP2140 serial interface and IR baud rates are
fixed at 9600 baud, given a 7.3728 MHz device clock.
2.1
Power-Up
Any time the device is powered up (Parameter D003),
the Power-Up Timer delay (Parameter 33) occurs, fol-
lowed by an Oscillator Start-up Timer (OST) delay
(Parameter 32). Once these delays complete, commu-
nication with the device may be initiated. This commu-
nication is from both the infrared transceiver’s side and
the controller’s UART interface.
2.2
Device Reset
The MCP2140 is forced into the reset state when the
RESET pin is in the low state. Once the RESET pin is
brought to a high state, the Device Reset sequence
occurs. Once the sequence completes, functional
operation begins.
2.3
Device Clocks
The MCP2140 requires a clock source to operate. This
clock source is used to establish the device timing,
including the device “Bit Clock”.
2.3.1
CLOCK SOURCE
The clock source can be supplied by one of the
following:
Crystal
Resonator
External clock
The frequency of this clock source must be
7.3728 MHz (electrical specification Parameter 1A) for
device communication at 9600 baud.
2.3.1.1
Crystal Oscillator / Ceramic
Resonators
A crystal or ceramic resonator can be connected to the
OSC1 and OSC2 pins to establish oscillation
(Figure 2-1). The MCP2140 oscillator design requires
the use of a parallel-cut crystal. Use of a series of cut
crystals may give a frequency outside of the crystal
manufacturers specifications.
FIGURE 2-1:
CRYSTAL OPERATION
(CERAMIC RESONATOR)
TABLE 2-1:
CAPACITOR SELECTION FOR
CERAMIC RESONATORS
TABLE 2-2:
CAPACITOR SELECTION FOR
CRYSTAL OSCILLATOR
Freq
OSC1 (C1)
OSC2 (C2)
7.3728 MHz
10 - 22 pF
Note:
Higher capacitance increases the stability
of the oscillator, but also increases the
start-up time. These values are for design
guidance only. Since each resonator has its
own characteristics, the user should consult
the resonator manufacturer for appropriate
values of external components.
Freq
OSC1 (C1)
OSC2 (C2)
7.3728 MHz
15 - 30 pF
Note:
Higher capacitance increases the stability
of the oscillator but also increases the start-
up time. These values are for design guid-
ance only. RS may be required to avoid
overdriving crystals with low drive level
specification. Since each crystal has its
own characteristics, the user should con-
sult
the
crystal
manufacturer
for
appropriate values of external components.
values of C1 and C2.
Note:
A series resistor may be required for
AT strip cut crystals.
C1
C2
XTAL
OSC2
RS
OSC1
RF
To internal
MCP2140
(Note)
logic
相關PDF資料 |
PDF描述 |
|---|---|
| MCP2140A-I/P | IC IRDA CONTROLLR DTE/DCE 18DIP |
| MCP2150T-I/SO | IC IRDA STD CONTROLLER 18SOIC |
| MCP2155-I/SS | IC IRDA PROTOCOL CTRLR 20SSOP |
| MCP2200-I/MQ | IC USB TO UART 20QFN |
| MCP2200T-I/MQ | IC USB 2.0 - UART 20QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP2140-ISO | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IrDA㈢ Standard Protocol Stack Controller With Fixed 9600 Baud Communication Rate |
| MCP2140-ISS | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IrDA㈢ Standard Protocol Stack Controller With Fixed 9600 Baud Communication Rate |
| MCP2140T-I/SO | 功能描述:網絡控制器與處理器 IC 9600bd fixd spd IrDA RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| MCP2140T-I/SS | 功能描述:網絡控制器與處理器 IC 9600bd fixd spd IrDA RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| MCP2140T-IP | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IrDA㈢ Standard Protocol Stack Controller With Fixed 9600 Baud Communication Rate |
發布緊急采購，3分鐘左右您將得到回復。