- 您現在的位置：買賣IC網 > PDF目錄9045 > MCP4706A0T-E/CH (Microchip Technology)IC DAC 8BIT NV EEP I2C SOT-23-6 PDF資料下載
參數資料
| 型號： | MCP4706A0T-E/CH |
| 廠商： | Microchip Technology |
| 文件頁數： | 29/86頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 8BIT NV EEP I2C SOT-23-6 |
| 標準包裝： | 1 |
| 設置時間： | 6µs |
| 位數： | 8 |
| 數據接口： | EEPROM，I²C，串行 |
| 轉換器數目： | 1 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 452mW |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-6 |
| 供應商設備封裝： | SOT-23-6 |
| 包裝： | 標準包裝 |
| 輸出數目和類型： | 1 電壓，單極 |
| 采樣率（每秒）： | * |
| 其它名稱： | MCP4706A0T-E/CHDKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁
2011-2012 Microchip Technology Inc.
DS22272C-page 35
MCP4706/4716/4726
4.0
GENERAL DESCRIPTION
The MCP4706, MCP4716, and MCP4726 devices are
single channel voltage output 8-bit, 10-bit, and 12-bit
DAC devices with nonvolatile memory (EEPROM) and
an I2C serial interface. This family will be referred to as
MCP47X6.
The devices use a resistor ladder architecture. The
resistor ladder DAC is driven from a software
selectable voltage reference source. The source can
be either the device’s internal VDD or the external VREF
pin voltage.
The DAC output is buffered with a low power and
precision output amplifier (op amp). This output
amplifier provides a rail-to-rail output with low offset
voltage and low noise. The gain of the output buffer is
software configurable.
This device also has user programmable nonvolatile
memory (EEPROM), which allows the user to save the
desired POR/BOR value of the DAC register and
device Configuration bits.
The devices use a two-wire I2C serial communication
interface and operate with a single supply voltage from
2.7V to 5.5V.
4.1
Power-On Reset/Brown-Out Reset
(POR/BOR)
The internal Power-on Reset (POR)/Brown-out Reset
(BOR) circuit monitors the power supply voltage (VDD)
during operation. This circuit ensures correct device
start-up at system power-up and power-down events.
VRAM is the RAM retention voltage and is always lower
than the POR trip point voltage.
POR occurs as the voltage is rising (typically from 0V),
while BOR occurs as the voltage is falling (typically
from VDD(MIN) or higher).
When the rising VDD voltage crosses the VPOR trip
point, the following occurs:
Nonvolatile DAC register value latched into
volatile DAC register
Nonvolatile Configuration bit values latched into
volatile Configuration bits
POR Status bit is set (“1”)
The Reset delay timer starts; when timer times
out (tPORD), the I
2C interface is operational.
The analog output (VOUT) state will be determined by
the state of the volatile Configuration bits and the DAC
register. This is called a POR Reset (event).
When the falling VDD voltage crosses the VPOR trip
point, the following occurs:
Device is forced into a power-down state
(PD1:PD0 = 11). Analog circuitry is turned off.
Volatile DAC register is forced to 000h
Volatile Configuration bits VREF1, VREF0 and G
are forced to ‘0’
Figure 4-1 illustrates the conditions for power-up and
power-down events under typical conditions.
FIGURE 4-1:
Power-on Reset Operation.
VPOR
TPORD
VDD(MIN)
Normal Operation
BOR Reset,
volatile DAC Register = 000h
volatile VREF1:VREF0 = 00
Device in
Below
VRAM
Device in
POR state
unknown
state
minimum
operating
voltage
Device in
unknown
state
Device
in power
down
state
(60 s max.)
volatile G = 0
volatile PD1:PD0 = 11
VBOR
Volatile memory
retains data value
Volatile memory
becomes corrupted
POR starts Reset Delay Timer.
When timer times out, I2C interface
can operate (if VDD >= VDD(MIN))
EEPROM data latched into volatile
Configuration bits and DAC register.
POR Status bit is set (“1”)
POR Reset forced active
相關PDF資料 |
PDF描述 |
|---|---|
| VI-BT4-MY-F2 | CONVERTER MOD DC/DC 48V 50W |
| VE-22P-MW-F3 | CONVERTER MOD DC/DC 13.8V 100W |
| M83723/74W22326 | CONN RCPT 32POS JAM NUT W/PINS |
| MK3732-10SLFTR | IC VCXO/MULTIPLIER 16-SOIC |
| VI-BT3-MY-F3 | CONVERTER MOD DC/DC 24V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP4706A1T-E/CH | 功能描述:數模轉換器- DAC Sngl 8B NV DAC w/Ext Vref & I2C interface RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MCP4706A1T-E/MAY | 功能描述:數模轉換器- DAC Sngl 8B NV DAC w/Ext Vref & I2C interface RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MCP4706A2T-E/CH | 功能描述:數模轉換器- DAC Sngl 8B NV DAC w/Ext Vref & I2C interface RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MCP4706A2T-E/MAY | 功能描述:數模轉換器- DAC Sngl 8B NV DAC w/Ext Vref & I2C interface RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MCP4706A3T-E/CH | 功能描述:數模轉換器- DAC Sngl 8B NV DAC w/Ext Vref & I2C interface RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。