- 您現在的位置：買賣IC網 > PDF目錄98013 > MCZ33781EK (FREESCALE SEMICONDUCTOR INC) SPECIALTY MICROPROCESSOR CIRCUIT, PDSO32 PDF資料下載
參數資料
| 型號： | MCZ33781EK |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | SPECIALTY MICROPROCESSOR CIRCUIT, PDSO32 |
| 封裝： | 0.65 MM, LEAD FREE, SOIC-32 |
| 文件頁數： | 26/44頁 |
| 文件大小： | 940K |
| 代理商： | MCZ33781EK |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁
Analog Integrated Circuit Device Data
32
Freescale Semiconductor
33781
FUNCTIONAL DEVICE OPERATION
LOGIC COMMANDS AND REGISTERS
DnRnH REGISTERS
These are read/write registers. There are sixteen of these
registers, four for each of the buses, as shown in Table 8.
When written to, the data is the high byte of a 9- to16-bit
command. When read, it is the high byte of a 9- to 16-bit
return on the DBUS. Writing to this register and the low byte
register without a framing error schedules a DBUS
transaction.
The bit assignments are shown in Figure 24. Even if a
short word of 8 bits is selected for this bus (MSn = 1), this
register must be written in the SPI burst sequence. When the
short word length is set at other than 8 bits, this register will
contain the bits above eight, starting with the ninth bit in the
least significant bit position of the register. Unused bit
positions are don’t care values.
Figure 24. DnRnH Data Register Bit Assignments
DnRnL REGISTERS
These are read/write registers. There are sixteen of these
registers, four for each of the buses. When written to, the data
is the low byte of a 16-bit command. When in read, it is the
low byte of a 16-bit return on the DBUS. Writing to this
register and the high byte register without a framing error,
schedules a DBUS transaction. The bit assignments are
shown in Figure 25
If this address is pointed to by the first SPI0 byte of a SPI
burst transaction, that transaction is ignored.
Figure 25. DnRnL Data Register Bit Assignments
DnRnSTAT REGISTER
There are read-only registers. These registers cover the
status of their associated DnRnH and DnRnl registers. The
values are latched when CS0 is asserted low. Any changes of
status detected by these bits will not update the register until
CS0
is de-asserted. This is done to ensure that partial
updates will not occur. If this address is pointed to by the first
SPI0 byte of a SPI burst transaction, that transaction is
ignored.
The bit assignments are shown in Figure 26.
Figure 26. DnRnSTAT Register Bit Assignments
ER–CRC Error Bit
0 = CRC value for the data in the read buffer was
correct.
1 = CRC value for the data in the read buffer was not
correct (data not valid).
CRC errors are associated with each receive buffer, so
that each buffer has a bit to indicate whether the data in that
buffer was received correctly. Whenever a received data
value is available in the DnRnH and DnRnL registers, the
associated CRC error status is available at ERn in the
associated DnRnSTAT register. The ER bit is set or cleared
whenever data is written from the DBUS into the DnRnH/L
receive registers. If Channel Thermal Shutdown or Idle and
SIgnal Mode Disable occur, these bits will be reset along with
the other channel register bits.
TE–Transmit Register Empty Bit
0 = Transmit buffer not empty.
1 = Transmit buffer empty.
This bit indicates that data has been written to the
associated channel register high and/or low, but has not been
read for sending on the DBUS. The bit is set to 0 on the rising
SPI Data Bit
Bit 7
6
5
4
3
2
1
0
Read/Write
Bit 15
Bit 14
Bit 13
Bit 12
Bit 11
Bit 10
Bit 9
Bit 8
Reset
0
SPI Data Bit
Bit 7
6
5
4
3
2
1
0
Read/Write
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Reset
0
SPI Data Bit
Bit 7
6
5
4
3
2
1
0
Read
ER
TE
SDS
RNE
ICL
0
FIX0
FIX1
Reset
0
1
0
1
相關PDF資料 |
PDF描述 |
|---|---|
| MD1802FH | 10 A, 700 V, NPN, Si, POWER TRANSISTOR, TO-220AB |
| MD1802FX | 10 A, 700 V, NPN, Si, POWER TRANSISTOR |
| MD1803DFH | 10 A, 700 V, NPN, Si, POWER TRANSISTOR, TO-220AB |
| MD2001FX | 12 A, 700 V, NPN, Si, POWER TRANSISTOR |
| MD2103DFX | 6 A, 700 V, NPN, Si, POWER TRANSISTOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCZ33781EKR2 | 功能描述:輸入/輸出控制器接口集成電路 DBUS2 MASTER STND RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| MCZ33784EF | 功能描述:加速計 - 板上安裝 DBUS2 SENSOR INTERFACE RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C |
| MCZ33784EF/R2- | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:DSI 2.02 Sensor Interface |
| MCZ33784EFR2 | 功能描述:加速計 - 板上安裝 DBUS2 SENSOR INTERFACE RoHS:否 制造商:Murata 傳感軸:Double 加速:12 g 靈敏度: 封裝 / 箱體: 輸出類型:Analog 數字輸出 - 位數:11 bit 電源電壓-最大:5.25 V 電源電壓-最小:4.75 V 電源電流:4 mA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C |
| MCZ33789AE | 功能描述:網絡控制器與處理器 IC Airbag ASSP RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。