參數資料
型號: MJE16106BC
廠商: ON SEMICONDUCTOR
元件分類: 功率晶體管
英文描述: 8 A, 400 V, NPN, Si, POWER TRANSISTOR
封裝: PLASTIC, TO-220AB, 3 PIN
文件頁數: 64/65頁
文件大?。?/td> 487K
代理商: MJE16106BC
MJE16106
3–703
Motorola Bipolar Power Transistor Device Data
TURN–ON
Safe turn–on load line excursions are bounded by pulsed
FBSOA curves. The 10
s curve applies for resistive loads,
most capacitive loads, and inductive loads that are clamped
by standard or fast recovery rectifiers. Similarly, the 100 ns
curve applies to inductive loads which are clamped by ultra–
fast recovery rectifiers, and are valid for turn–on crossover
times less than 100 ns (AN952).
At voltages above 75% of V(BR)CEO(sus), it is essential
to provide the transistor with an adequate amount of base
drive VERY RAPIDLY at turn–on. More specifically, safe op-
eration according to the curves is dependent upon base cur-
rent rise time being less than collector current rise time. As a
general rule, a base drive compliance voltage in excess of
10 volts is required to meet this condition (see Application
Note AN875).
TURN–OFF
A bipolar transistor’s ability to withstand turn–off stress is
dependent upon its forward base drive. Gross overdrive vio-
lates the RBSOA curve and risks transistor failure. For this
reason, circuits which use fixed base drive are more likely to
fail at light loads due to heavy overdrive (see Application
Note AN875).
OPERATION ABOVE V(BR)CEO(sus)
When bipolars are operated above collector–emitter
breakdown, base drive is crucial. A rapid application of ade-
quate forward base current is needed for safe turn–on, as is
a stiff negative bias needed for safe turn–off. Any hiccup in
the base–drive circuitry that even momentarily violates either
of these conditions will likely cause the transistor to fail.
Therefore, it is important to design the driver so that its out-
put is negative in the absence of anything but a clean crisp
input signal (see Application Note AN952).
RBSOA
Reversed Biased Safe Operating Area has a first order de-
pendency on circuit configuration and drive parameters. The
RBSOA curves in this data sheet are valid only for the condi-
tions specified. For a comparison of RBSOA results in sever-
al types of circuits (see Application Note AN951).
DESIGN SAMPLES
Transistor parameters tend to vary much more from wafer
lot to wafer lot, over long periods of time, than from one de-
vice to the next in the same wafer lot. For design evaluation
it is advisable to use transistors from several different date
codes.
BAKER CLAMPS
Many unanticipated pitfalls can be avoided by using Baker
Clamps. MUR105 and MUR170 diodes are recommended
for base drives less than 1 amp. Similarly, MUR405 and
MUR470 types are well–suited for higher drive requirements
(see Article Reprint AR131).
相關PDF資料
PDF描述
MJE16106AU 8 A, 400 V, NPN, Si, POWER TRANSISTOR
MJE16106AK 8 A, 400 V, NPN, Si, POWER TRANSISTOR
MJE16106AN 8 A, 400 V, NPN, Si, POWER TRANSISTOR
MJE16106AS 8 A, 400 V, NPN, Si, POWER TRANSISTOR
MJE16106BU 8 A, 400 V, NPN, Si, POWER TRANSISTOR
相關代理商/技術參數
參數描述
MJE16204 制造商:ON Semiconductor 功能描述:TRANSISTOR, NPN TO-220
MJE170 功能描述:兩極晶體管 - BJT 3A 40V 12.5W PNP RoHS:否 制造商:STMicroelectronics 配置: 晶體管極性:PNP 集電極—基極電壓 VCBO: 集電極—發射極最大電壓 VCEO:- 40 V 發射極 - 基極電壓 VEBO:- 6 V 集電極—射極飽和電壓: 最大直流電集電極電流: 增益帶寬產品fT: 直流集電極/Base Gain hfe Min:100 A 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PowerFLAT 2 x 2
MJE170G 功能描述:兩極晶體管 - BJT 3A 40V 12.5W PNP RoHS:否 制造商:STMicroelectronics 配置: 晶體管極性:PNP 集電極—基極電壓 VCBO: 集電極—發射極最大電壓 VCEO:- 40 V 發射極 - 基極電壓 VEBO:- 6 V 集電極—射極飽和電壓: 最大直流電集電極電流: 增益帶寬產品fT: 直流集電極/Base Gain hfe Min:100 A 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PowerFLAT 2 x 2
MJE170STU 功能描述:兩極晶體管 - BJT PNP Epitaxial Sil RoHS:否 制造商:STMicroelectronics 配置: 晶體管極性:PNP 集電極—基極電壓 VCBO: 集電極—發射極最大電壓 VCEO:- 40 V 發射極 - 基極電壓 VEBO:- 6 V 集電極—射極飽和電壓: 最大直流電集電極電流: 增益帶寬產品fT: 直流集電極/Base Gain hfe Min:100 A 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PowerFLAT 2 x 2
MJE171 功能描述:兩極晶體管 - BJT 3A 60V 12.5W PNP RoHS:否 制造商:STMicroelectronics 配置: 晶體管極性:PNP 集電極—基極電壓 VCBO: 集電極—發射極最大電壓 VCEO:- 40 V 發射極 - 基極電壓 VEBO:- 6 V 集電極—射極飽和電壓: 最大直流電集電極電流: 增益帶寬產品fT: 直流集電極/Base Gain hfe Min:100 A 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PowerFLAT 2 x 2