參數資料
型號: MP80C51-36D
廠商: TEMIC SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 36 MHz, MICROCONTROLLER, PDIP40
文件頁數: 82/170頁
文件大?。?/td> 4133K
代理商: MP80C51-36D
19
ATtiny4/5/9/10 [DATASHEET]
8127F–AVR–02/2013
6.2.3
Internal 128 kHz Oscillator
The internal 128 kHz oscillator is a low power oscillator providing a clock of 128 kHz. The frequency depends on
supply voltage, temperature and batch variations. This clock may be select as the main clock by setting the
CLKMS[1:0] bits in CLKMSR to 0b01.
6.2.4
Switching Clock Source
The main clock source can be switched at run-time using the “CLKMSR – Clock Main Settings Register” on page
21. When switching between any clock sources, the clock system ensures that no glitch occurs in the main clock.
6.2.5
Default Clock Source
The calibrated internal 8 MHz oscillator is always selected as main clock when the device is powered up or has
been reset. The synchronous system clock is the main clock divided by 8, controlled by the System Clock Pres-
caler. The Clock Prescaler Select Bits can be written later to change the system clock frequency. See “System
6.3
System Clock Prescaler
The system clock is derived from the main clock via the System Clock Prescaler. The system clock can be divided
by setting the “CLKPSR – Clock Prescale Register” on page 22. The system clock prescaler can be used to
decrease power consumption at times when requirements for processing power is low or to bring the system clock
within limits of maximum frequency. The prescaler can be used with all main clock source options, and it will affect
the clock frequency of the CPU and all synchronous peripherals.
The System Clock Prescaler can be used to implement run-time changes of the internal clock frequency while still
ensuring stable operation.
6.3.1
Switching Prescaler Setting
When switching between prescaler settings, the system clock prescaler ensures that no glitch occurs in the system
clock and that no intermediate frequency is higher than neither the clock frequency corresponding the previous set-
ting, nor the clock frequency corresponding to the new setting.
The ripple counter that implements the prescaler runs at the frequency of the main clock, which may be faster than
the CPU's clock frequency. Hence, it is not possible to determine the state of the prescaler - even if it were read-
able, and the exact time it takes to switch from one clock division to another cannot be exactly predicted.
From the time the CLKPS values are written, it takes between T1 + T2 and T1 + 2*T2 before the new clock fre-
quency is active. In this interval, two active clock edges are produced. Here, T1 is the previous clock period, and
T2 is the period corresponding to the new prescaler setting.
相關PDF資料
PDF描述
MV80C51T-12R 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP44
MF280C51C-36D 8-BIT, MROM, 36 MHz, MICROCONTROLLER, PQFP44
MS80C51T-16R 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQCC44
MV80C51C-12R 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP44
MF180C51T-16D 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP44
相關代理商/技術參數
參數描述
MP81 制造商:未知廠家 制造商全稱:未知廠家 功能描述:BRIDGE RECTIFIERS
MP810 制造商:GOOD-ARK 制造商全稱:GOOD-ARK Electronics 功能描述:SILICON BRIDGE RECTIFIERS
MP-810 制造商:JAMECO BENCHPRO 功能描述:4-Piece Plier/Cutter/Screwdrivers Set
MP8100 制造商:MPS 制造商全稱:Monolithic Power Systems 功能描述:Precision High-Side Current-Sense Amplifier
MP8100DS 制造商:MPS 制造商全稱:Monolithic Power Systems 功能描述:Precision High-Side Current-Sense Amplifier