MPC5561 Microcontroller Data Sheet, Rev. 2.0
Revision History for the MPC5561 Data Sheet
Freescale Semiconductor
48
The following table describes the changes made to information in tables and figures:
Added the following text directly before this section and after
Table 8 Pin Status for Medium / Slow Pads During the
Power-on Sequence:
‘The values in
Table 7 and
Table 8 do not include the effect of the weak pull devices on the output pins during power
up.
Before exiting the internal POR state, the voltage on the pins goes to high-impedance until POR negates. When the
internal POR negates, the functional state of the signal during reset applies and the weak pull devices (up or down)
are enabled as defined in the device Reference Manual. If VDD is too low to correctly propagate the logic signals,
the weak-pull devices can pull the signals to VDDE and VDDEH.
To avoid this condition, minimize the ramp time of the VDD supply to a time period less than the time required to
enable the external circuitry connected to the device outputs.’
Section 3.13.6, “eTPU Timing”
Deleted entire section, including table and figure, because the MPC5561 does not have the eTPU module.
Table 28. Table and Figure Changes Between Rev. 0.0 and 1.0
Location
Description of Changes
Removed the 2 in the tape and reel designator in both the graphic and in the Tape and Reel Status text.
Changed Qualification Status by adding ‘, general market flow’ to the M designator, and added an ‘S’ designator
with the description of ‘Fully spec. qualified, automotive flow.
Changed footnote 1 to read: All devices are PPC5561, rather than MPC5561 or SPC5561, until product
qualifications are complete. Not all configurations are available in the PPC parts.
Increased the frequency values in the Maximum column by 2 ns.
Changed the maximum operating frequency from 132 MHz to 135 MHz.
Reordered rows to group devices by lead-free package types in descending frequency order, and leaded
package types.
Footnote 2: added ‘a(chǎn)mbient’ between ‘lowest’ and ‘operating’ and ‘highest’ and ‘operating.’
Changed footnote 3 from ‘132 MHz allows only 128 MHz + 2% FM’ to ‘135 MHz allows for 132 MHz + 2% FM’.
Table 27. Global and Text Changes Between Rev. 0.0 and Rev. 1.0 (continued)
Location
Description of Changes