- 您現在的位置：買賣IC網 > PDF目錄359201 > MPXV2010G (飛思卡爾半導體(中國)有限公司) 10 kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors PDF資料下載
參數資料
| 型號： | MPXV2010G |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 英文描述： | 10 kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors |
| 中文描述： | 10千帕片上溫度補償 |
| 文件頁數： | 5/14頁 |
| 文件大小： | 361K |
| 代理商： | MPXV2010G |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁
MPX2010
Sensors
Freescale Semiconductor
5
LINEARITY
Linearity refers to how well a transducer's output follows
the equation: V
out
= V
off
+ sensitivity x P over the operating
pressure range. There are two basic methods for calculating
nonlinearity: (1) end point straight line fit (see
Figure 4
) or
(2) a least squares best line fit. While a least squares fit gives
the “best case” linearity error (lower numerical value), the
calculations required are burdensome.
Conversely, an end point fit will give the “worst case” error
(often more desirable in error budget calculations) and the
calculations are more straightforward for the user.
Freescale’s specified pressure sensor linearities are based
on the end point straight line method measured at the
midrange pressure.
Figure 4. Linearity Specification Comparison
PRESSURE (P1)/VACUUM (P2) SIDE IDENTIFICATION TABLE
Freescale designates the two sides of the pressure sensor
as the Pressure (P1) side and the Vacuum (P2) side. The
Pressure (P1) side is the side containing silicone gel which
isolates the die from the environment. The Freescale MPX
pressure sensor is designed to operate with positive
differential pressure applied, P1 > P2.
The Pressure (P1) side may be identified by using the
following table.
Least
Square
Deviation
R
Pressure (% Full Scale)
0
50
100
End Point Straight
Line Fit
Exaggerated
Performance
Curve
Least Squares Fit
Offset
Straight Line
Deviation
Table 3. Pressure (P1) Side Delineation
Part Number
Case Type
Pressure (P1) Side Identifier
MPX2010D
344
Stainless Steep Cap
MPX2010DP
344C
Side with Part Marking
MPX2010GP
344B
Side with Port Attached
MPX2010GS
344E
Side with Port Attached
MPX2010GSX
344F
Side with Port Attached
MPXV2010GP
1369
Side with Port Attached
MPXV2010DP
1351
Side with Part Marking
相關PDF資料 |
PDF描述 |
|---|---|
| MPXV2053DP | 50kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors(50kPa片內溫度補償和校準硅壓力傳感器) |
| MPXV2102DP | 100kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors(100kPa片內溫度補償和校準硅壓力傳感器) |
| MPXV2202DP | 200kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors(200kPa片內溫度補償和校準硅壓力傳感器) |
| MPXV4006G6U | Integrated Silicon Pressure Sensor On-Chip Signal Conditioned, Temperature Compensated and Calibrated(集成硅壓力傳感器，帶片內信號調節、溫度補償和校準功能) |
| MPXV4115V | Integrated Silicon Pressure Sensor On-Chip Signal Conditioned, |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPXV2010GP | 功能描述:板上安裝壓力/力傳感器 SOP TOP SIDE PORT RoHS:否 制造商:Honeywell 工作壓力:0 bar to 4 bar 壓力類型:Gage 準確性:+ / - 0.25 % 輸出類型:Digital 安裝風格:Through Hole 工作電源電壓:5 V 封裝 / 箱體:SIP 端口類型:Dual Radial Barbed, Same sides |
| MPXV2010GP | 制造商:Freescale Semiconductor 功能描述:Pressure Sensors IC |
| MPXV2050 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:50 kPa On-Chip Temperature Compensated and Calibrated Silicon Pressure Sensors |
| MPXV2050GP | 功能描述:板上安裝壓力/力傳感器 SOP TOP PORT RoHS:否 制造商:Honeywell 工作壓力:0 bar to 4 bar 壓力類型:Gage 準確性:+ / - 0.25 % 輸出類型:Digital 安裝風格:Through Hole 工作電源電壓:5 V 封裝 / 箱體:SIP 端口類型:Dual Radial Barbed, Same sides |
| MPXV2053DP | 功能描述:板上安裝壓力/力傳感器 SOP DUAL PORT RoHS:否 制造商:Honeywell 工作壓力:0 bar to 4 bar 壓力類型:Gage 準確性:+ / - 0.25 % 輸出類型:Digital 安裝風格:Through Hole 工作電源電壓:5 V 封裝 / 箱體:SIP 端口類型:Dual Radial Barbed, Same sides |
發布緊急采購，3分鐘左右您將得到回復。