- 您現在的位置：買賣IC網 > PDF目錄25639 > MR83C154XXX-25P883 (ATMEL CORP) 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44 PDF資料下載
參數資料
| 型號： | MR83C154XXX-25P883 |
| 廠商： | ATMEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44 |
| 封裝： | LCC-44 |
| 文件頁數： | 45/80頁 |
| 文件大?。?/td> | 5152K |
| 代理商： | MR83C154XXX-25P883 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁當前第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
245
XMEGA A [MANUAL]
8077I–AVR–11/2012
21.14 DMA Support
DMA support is available on UART, USRT, and master SPI mode peripherals. For details on different USART DMA
transfer triggers, refer to “Transfer Triggers” on page 52.
21.15 Register Description
21.15.1 DATA – Data register
The USART transmit data buffer register (TXB) and USART receive data buffer register (RXB) share the same I/O
address and is referred to as USART data register (DATA). The TXB register is the destination for data written to the
DATA register location. Reading the DATA register location returns the contents of the RXB register.
For 5-bit, 6-bit, or 7-bit characters, the upper unused bits will be ignored by the transmitter and set to zero by the receiver.
The transmit buffer can be written only when DREIF in the STATUS register is set. Data written to the DATA register
when DREIF is not set will be ignored by the USART transmitter. When data are written to the transmit buffer and the
transmitter is enabled, the transmitter will load the data into the transmit shift register when the shift register is empty.
The data are then transmitted on the TxD pin.
The receive buffer consists of a two-level FIFO. Always read STATUS before DATA in order to get the correct status of
the receive buffer.
21.15.2 STATUS – Status register
Bit 7 – RXCIF: Receive Complete Interrupt Flag
This flag is set when there are unread data in the receive buffer and cleared when the receive buffer is empty (i.e., does
not contain any unread data). When the receiver is disabled, the receive buffer will be flushed, and consequently RXCIF
will become zero.
When interrupt-driven data reception is used, the receive complete interrupt routine must read the received data from
DATA in order to clear RXCIF. If not, a new interrupt will occur directly after the return from the current interrupt. This flag
can also be cleared by writing a one to its bit location.
Bit 6 – TXCIF: Transmit Complete Interrupt Flag
This flag is set when the entire frame in the transmit shift register has been shifted out and there are no new data in the
transmit buffer (DATA). TXCIF is automatically cleared when the transmit complete interrupt vector is executed. The flag
can also be cleared by writing a one to its bit location.
Bit 5 – DREIF: Data Register Empty Flag
This flag indicates whether the transmit buffer (DATA) is ready to receive new data. The flag is one when the transmit
buffer is empty and zero when the transmit buffer contains data to be transmitted that has not yet been moved into the
shift register. DREIF is set after a reset to indicate that the transmitter is ready. Always write this bit to zero when writing
the STATUS register.
Bit
7654
3210
+0x00
RXB[[7:0]
TXB[[7:0]
Read/Write
R/W
Initial Value
0
Bit
7654
3210
+0x01
RXCIF
TXCIF
DREIF
FERR
BUFOVF
PERR
–RXB8
Read/Write
R
R/W
R
R/W
Initial Value
0
1
0
相關PDF資料 |
PDF描述 |
|---|---|
| MS80C51-12D | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQCC44 |
| MT80C51T-16R | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP44 |
| MD80C32E-20SC | 8-BIT, 20 MHz, MICROCONTROLLER, CDIP40 |
| MC80C52XXX-16SHXXX | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40 |
| MD80C52EXXX-20 | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CDIP40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MR850 | 功能描述:整流器 3.0 Amp 50 Volt 150ns RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| MR850 _AY _10001 | 制造商:PanJit Touch Screens 功能描述: |
| MR850 R0 | 制造商:SKMI/Taiwan 功能描述:Diode Switching 50V 3A 2-Pin DO-201AD T/R |
| MR850_ R2 _10001 | 制造商:PanJit Touch Screens 功能描述: |
| MR850_09 | 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:SOFT RECOVERY, FAST SWITCHING PLASTIC RECTIFIER |
發布緊急采購，3分鐘左右您將得到回復。