- 您現在的位置：買賣IC網 > PDF目錄25639 > MR83C154XXX-25P883 (ATMEL CORP) 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44 PDF資料下載
參數資料
| 型號： | MR83C154XXX-25P883 |
| 廠商： | ATMEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44 |
| 封裝： | LCC-44 |
| 文件頁數： | 56/80頁 |
| 文件大小： | 5152K |
| 代理商： | MR83C154XXX-25P883 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
256
XMEGA A [MANUAL]
8077I–AVR–11/2012
Figure 23-1. Register file usage during DES encryption/decryption.
Executing one DES instruction performs one round in the DES algorithm. Sixteen rounds must be executed in increasing
order to form the correct DES ciphertext or plaintext. Intermediate results are stored in the register file (R0-R15) after
each DES instruction. After sixteen rounds, the key is located in R8-R16 and the encrypted/decrypted ciphertext/plaintext
is located in R0-R7. The instruction's operand (K) determines which round is executed, and the half carry flag (H) in the
CPU status register determines whether encryption or decryption is performed. If the half carry flag is set, decryption is
performed, and if the flag is cleared, encryption is performed.
For more details on the DES instruction, refer to the AVR instruction set manual.
23.4
AES Crypto Module
The AES crypto module performs encryption and decryption according to the Advanced Encryption Standard (FIPS-197).
The 128-bit key block and 128-bit data block (plaintext or ciphertext) must be loaded into the key and state memories in
the AES crypto module. This is done by writing the AES KEY register and STATE register sequentially with 16 bytes.
It is software selectable whether the module should perform encryption or decryption. It is also possible to enable XOR
mode, where all new data loaded to the state key is XORed with the current data in the state memory.
The AES module uses 375 clock cycles before the encrypted/decrypted plaintext/ciphertext is available for readout in the
state memory.
The following setup and use procedure is recommended:
1.
Enable the AES interrupt (optional).
2.
Select the AES direction to encryption or decryption.
3.
Load the key data block into the AES key memory.
4.
Load the data block into the AES state memory.
5.
Start the encryption/decryption operation.
If more than one block is to be encrypted or decrypted, repeat the procedure from step 3.
When the encryption/decryption procedure is complete, the AES interrupt flag is set and an optional interrupt is
generated.
Register File
R0
R1
R2
R3
R4
R5
R6
R7
R8
R9
R10
R11
R12
R13
R14
R15
R16
...
R31
data0
data1
data2
data3
data4
data5
data6
data7
key0
key1
key2
key3
key4
key5
key6
key7
data
key
相關PDF資料 |
PDF描述 |
|---|---|
| MS80C51-12D | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQCC44 |
| MT80C51T-16R | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP44 |
| MD80C32E-20SC | 8-BIT, 20 MHz, MICROCONTROLLER, CDIP40 |
| MC80C52XXX-16SHXXX | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CDIP40 |
| MD80C52EXXX-20 | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CDIP40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MR850 | 功能描述:整流器 3.0 Amp 50 Volt 150ns RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| MR850 _AY _10001 | 制造商:PanJit Touch Screens 功能描述: |
| MR850 R0 | 制造商:SKMI/Taiwan 功能描述:Diode Switching 50V 3A 2-Pin DO-201AD T/R |
| MR850_ R2 _10001 | 制造商:PanJit Touch Screens 功能描述: |
| MR850_09 | 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:SOFT RECOVERY, FAST SWITCHING PLASTIC RECTIFIER |
發布緊急采購，3分鐘左右您將得到回復。