- 您現在的位置：買賣IC網 > PDF目錄383639 > MRF24J40 (Microchip Technology Inc.) IEEE 802.15.4⑩ 2.4 GHz RF Transceiver PDF資料下載
參數資料
| 型號： | MRF24J40 |
| 廠商： | Microchip Technology Inc. |
| 英文描述： | IEEE 802.15.4⑩ 2.4 GHz RF Transceiver |
| 中文描述： | IEEE 802.15.4標準⑩2.4 GHz射頻收發器 |
| 文件頁數： | 33/66頁 |
| 文件大?。?/td> | 748K |
| 代理商： | MRF24J40 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁
2006 Microchip Technology Inc.
Advance Information
DS39776A-page 31
MRF24J40
7.2.2
TRANSMISSION STATUS
When a transmission completes, the TXIF flag of the
ISRSTS register will become set. Once the TXIF bit is
set, the status of the transmission is located in the
TXSR register.
7.3
Receiving Packets
The following section details the reception of a
non-secured frame. When the MRF24J40 receives a
packet that passes the MAC layer addressing, thresh-
old and packet type filters, it will indicate the reception
of this packet to the host controller by setting the RXIF
bit (ISRSTS<3>). The packet will remain in the buffer
until the host frees the buffer. No other packets can be
received while the buffer is holding a packet.
7.4
RX MAC
The RX MAC block will do CRC checking, parse the
received frame type and address recognition, then
store the received frame into RX FIFO. In addition to
the IEEE 802.15.4 packet, there are also 2 bytes of
information that are appended to the end of the packet
after the FCS field: LQI and RSSI.
The behavior of RX FIFO follows a certain rule. When
a received packet is not filtered or dropped, a received
interrupt/status will be issued. The interrupt is
read-to-clear to save host operation time. However, the
RX FIFO is flushed only using the following three
methods:
The host reads the first byte and the last byte to
the packet
The host issues RX flush
A software is reset
For RX filter function, the Promiscuous mode is
supported to receive all FCS-ok packets. An Error mode
is supported to receive all packets that successfully
correlated PHY level preamble and delimiter.
REGISTER 7-2:
TXSR: TX MAC STATUS REGISTER
R-0
R-0
R-0
R-0
r
R-0
r
R-0
r
R-0
r
R-0
r
TXRETRY<7:6>
CCAFAIL
bit 7
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7-6
TXRETRY7:TXRETRY6:
Retry Times bits
Defines the retry times of the most recent TXN FIFO transmission.
CCAFAIL:
Clear Channel Assessment (CCA) Status of Last Transmission bit
1
= CCA failed
0
= CCA passed
Reserved:
Maintain as ‘
0
’
bit 5
bit 4-0
相關PDF資料 |
PDF描述 |
|---|---|
| MRF24J40-I | IEEE 802.15.4⑩ 2.4 GHz RF Transceiver |
| MRF24J40-IMM | IEEE 802.15.4⑩ 2.4 GHz RF Transceiver |
| MRSM75 | Rotation detection MR sensor |
| MRUS51S | Micro power Built-in IC ultra-minimum MR sensor |
| MS-012AA | SOIC: 8−LEAD (POWER ICS ONLY) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MRF24J40_08 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IEEE 802.15.4? 2.4 GHz RF Transceiver |
| MRF24J40_10 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IEEE 802.15.4a?￠ 2.4 GHz RF Transceiver |
| MRF24J40-I | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IEEE 802.15.4⑩ 2.4 GHz RF Transceiver |
| MRF24J40-I/ML | 功能描述:射頻收發器 2.4 Ghz IEEE/ZigBee RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| MRF24J40-I/ML | 制造商:Microchip Technology Inc 功能描述:ZIGBEE Transceiver IC |
發布緊急采購，3分鐘左右您將得到回復。