- 您現在的位置：買賣IC網 > PDF目錄383639 > MRF24J40 (Microchip Technology Inc.) IEEE 802.15.4⑩ 2.4 GHz RF Transceiver PDF資料下載
參數資料
| 型號： | MRF24J40 |
| 廠商： | Microchip Technology Inc. |
| 英文描述： | IEEE 802.15.4⑩ 2.4 GHz RF Transceiver |
| 中文描述： | IEEE 802.15.4標準⑩2.4 GHz射頻收發器 |
| 文件頁數： | 9/66頁 |
| 文件大?。?/td> | 748K |
| 代理商： | MRF24J40 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁
2006 Microchip Technology Inc.
Advance Information
DS39776A-page 7
MRF24J40
2.0
EXTERNAL CONNECTIONS
2.1
Oscillator
The MRF24J40 is designed to operate at 20 MHz with
a crystal connected to the OSC1 and OSC2 pins. A
typical oscillator circuit is shown in Figure 2-1.
FIGURE 2-1:
CRYSTAL OSCILLATOR
OPERATION
2.2
Oscillator Start-up
The MRF24J40 PHY has an internal PLL that must lock
before the device is capable of transmitting or receiving
packets. After a full Power-on Reset, the device
requires 2 ms to lock. During this delay, all registers
and buffer memory may still be read and written to
through the SPI bus. However, software should not
attempt to transmit any packets (set the TXRTS
(TXNMTRIG<0>)), or access any MAC or PHY
registers during this period.
2.3
CLKOUT Pin
The clock out pin is provided to the system designer for
use as the host controller clock or as a clock source for
other devices in the system. The CLKOUT has an inter-
nal prescaler which can divide the output by 1, 2, 4 or 8.
The CLKOUT function is enabled via the CLKCTRL
register (Register 2-1) and the prescaler is selected via
the RFCTRL7 register (Register 2-2).
Note
1:
A series resistor (R
S
) may be required for AT
strip cut crystals.
C1
C2
XTAL
OSC2
OSC1
Logic
MRF24J40
R
S
(1)
To Internal
REGISTER 2-1:
CLKCTRL: DIVIDED SLEEP CLOCK (50 kHz) SELECTION REGISTER
R/W-0
r
U-0
—
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
CLKOEN
SCLKDIV<4:0>
bit 7
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7
bit 6
bit 5
Reserved:
Maintain as ‘
0
’
Unimplemented:
Read as ‘
0
’
CLKOEN:
20 MHz Clock Output Enable bit
1
= Disable
0
= Enable
SCLKDIV4:SCLKDIV0:
Divided SLPCLK Selection bits
Divided by 2
n
.
bit 4-0
相關PDF資料 |
PDF描述 |
|---|---|
| MRF24J40-I | IEEE 802.15.4⑩ 2.4 GHz RF Transceiver |
| MRF24J40-IMM | IEEE 802.15.4⑩ 2.4 GHz RF Transceiver |
| MRSM75 | Rotation detection MR sensor |
| MRUS51S | Micro power Built-in IC ultra-minimum MR sensor |
| MS-012AA | SOIC: 8−LEAD (POWER ICS ONLY) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MRF24J40_08 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IEEE 802.15.4? 2.4 GHz RF Transceiver |
| MRF24J40_10 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IEEE 802.15.4a?￠ 2.4 GHz RF Transceiver |
| MRF24J40-I | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:IEEE 802.15.4⑩ 2.4 GHz RF Transceiver |
| MRF24J40-I/ML | 功能描述:射頻收發器 2.4 Ghz IEEE/ZigBee RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| MRF24J40-I/ML | 制造商:Microchip Technology Inc 功能描述:ZIGBEE Transceiver IC |
發布緊急采購，3分鐘左右您將得到回復。