參數資料
型號： MT9075BL
廠商： Mitel Networks Corporation
英文描述： E1 Single Chip Transceiver
中文描述： 素E1單芯片收發器
文件頁數： 10/78頁
文件大?。?/td> 1008K
代理商： MT9075BL
MT9075A
Preliminary Information
4-138
Figure 7 - Crystal Oscillator Circuit
Jitter Attenuator (JA)
The MT9075A Jitter Attenuator (JA), which consists
of a Phase Locked Loop (PLL) and data FIFO, can
be used on either the transmit or receive side of the
interface.
On the transmit side the C4b signal clocks the data
into the FIFO, the PLL de-jitters the C4b clock and
the resulting clean C4b signal clocks the data out of
the FIFO.
When the JA is selected on the receive side, the
extracted clock signal clocks the data into the FIFO.
The same clock feeds the PLL and the resulting de-
jittered clock is used to clock the data out of the
FIFO.
The JA meets the jitter transfer characteristics as
proposed
by
G.823
recommendations as shown in Figure 8. The JA
FIFO depth can be selected to be from 16 to 128
words deep, in multiples of 16 (2-bit) words. Its read
pointer can be centered by changing the JFC bit
(address 18H of page 02H) to provide maximum jitter
tolerance. If the read pointer should come within 4
bits of either end of the FIFO, the read clock
frequency will be increased or decreased by 0.0625
UI to correct the situation. The maximum time
needed to centre is T
max
= 3904
Depth ns, where
Depth is the selected JA FIFO depth. During this
time the JA will not attenuate jitter.
and
the
relevant
To ensure normal operation, the JA FIFO depth
should be set in software to be larger than the
anticipated maximum UI of input jitter.
Clock Jitter Attenuation Modes
MT9075A has three basic jitter attenuation modes of
operation, selected by the BS/LS and BL/FR control
pins.
System Bus Synchronous Mode.
Line Synchronous Mode.
Free-run mode.
MT9075A
OSC1
OSC2
20MHz
1M
56pF
39pF
1
μ
H*
100
Note: the 1
μ
H inductor is optional
Figure 8 - Typical Jitter Attenuation Curve
-19.5
dB
0.5
0
J
10
40
400
10K
-20 dB/decade
Frequency (Hz)
相關PDF資料
PDF描述
MT9075BP E1 Single Chip Transceiver
MT9075B-1 E1 Single Chip Transceiver
MT9075 ()
MT9076 T1/E1/J1 3.3V Single Chip Transceiver
MT9076AB T1/E1/J1 3.3V Single Chip Transceiver
相關代理商/技術參數
參數描述
MT9075BL1 制造商:Microsemi Corporation 功能描述:FRAMER E1 5V 100MQFP - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TXRX SGL E1 W/LIU 100MQFP 制造商:Microsemi Corporation 功能描述:IC TXRX SGL E1 W/LIU 100MQFP
MT9075BP 制造商:Microsemi Corporation 功能描述:
MT9075BP1 制造商:Microsemi Corporation 功能描述:Single Chip Transceiver 1TX 1RX 2.048Mbps 68-Pin PLCC Tube 制造商:Microsemi Corporation 功能描述:FRAMER E1 5V 68PLCC - Rail/Tube 制造商:Microsemi Corporation 功能描述:PB FREE E1 SINGLE CHIP TRANSCEIVER 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TXRX SGL E1 W/LIU 68PLCC 制造商:Microsemi Corporation 功能描述:IC TXRX SGL E1 W/LIU 68PLCC
MT9075BPR 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:E1 Single Chip Transceiver
MT9075BPR1 制造商:Microsemi Corporation 功能描述:FRAMER E1 5V 68PLCC - Tape and Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*