- 您現在的位置：買賣IC網 > PDF目錄5299 > OP162GSZ-REEL7 (Analog Devices Inc)IC OPAMP GP R-R 15MHZ LN 8SOIC PDF資料下載
參數資料
| 型號： | OP162GSZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 6/20頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP GP R-R 15MHZ LN 8SOIC |
| 標準包裝： | 1,000 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 13 V/µs |
| 增益帶寬積： | 15MHz |
| 電流 - 輸入偏壓： | 260nA |
| 電壓 - 輸入偏移： | 25µV |
| 電流 - 電源： | 650µA |
| 電流 - 輸出 / 通道： | 30mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 12 V，±1.35 V ~ 6 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 帶卷 (TR) |
OP162/OP262/OP462
Data Sheet
Rev. H | Page 14 of 20
Figure 34. Maximum Power Dissipation vs. Temperature for
14-Lead Package Types
UNUSED AMPLIFIERS
It is recommended that any unused amplifiers in a dual or a
quad package be configured as a unity-gain follower with a
1 k feedback resistor connected from the inverting input to
the output, and the noninverting input tied to the ground plane.
POWER-ON SETTLING TIME
The time it takes for the output of an op amp to settle after a
supply voltage is delivered can be an important consideration in
some power-up-sensitive applications. An example of this
would be in an A/D converter where the time until valid data
can be produced after power-up is important.
The OPx62 family has a rapid settling time after power-up.
Figure 35 shows the OP462 output settling times for a single-
used to find the power-on settling times for the device.
Figure 35. Oscilloscope Photo of VS and VOUT
Figure 36. Test Circuit for Power-On Settling Time
CAPACITIVE LOAD DRIVE
The OP162/OP262/OP462 are high speed, extremely accurate
devices that tolerate some capacitive loading at their outputs. As
load capacitance increases, unity-gain bandwidth of an OPx62
device decreases. This also causes an increase in overshoot and
settling time for the output. Figure 38 shows an example of this
with the device configured for unity gain and driving a 10 k
resistor and 300 pF capacitor placed in parallel.
By connecting a series R-C network, commonly called a
“snubber” network, from the output of the device to ground,
this ringing can be eliminated and overshoot can be
significantly reduced. Figure 37 shows how to set up the
snubber network, and Figure 39 shows the improvement in
output response with the network added.
Figure 37. Snubber Network Compensation for Capacitive Loads
Figure 38. A Photo of a Ringing Square Wave
AMBIENT TEMPERATURE (
°C)
MAXIMUM
POWER
DISSIPATION
(Watts)
0.3
0.4
0.5
0.6
0.7
0.8
0.9
1.0
1.1
1.2
0.1
0.2
0
20
45
70
95
120
00288-037
14-LEAD SOIC
14-LEAD TSSOP
10
0%
100
90
500ns
2V
50mV
VS = 5V
AV = 1
RL = 10k
00288-038
OP462
VOUT
0 TO +5V
SQUARE
10K
00288-039
1
OPx62
VIN
VOUT
RX
CX
CL
5V
00288-040
00288-
041
50mV
1s
100
90
10
0%
VS = 5V
AV = 1
CL = 300pF
RL = 10k
相關PDF資料 |
PDF描述 |
|---|---|
| AD8065ARZ-REEL7 | IC OPAMP VF R-R LN LP 30MA 8SOIC |
| 0459844221 | CONN RCPT R/A 4PWR 16SGL 3.18MM |
| 2060.0006.11 | FUSE 250MA 125V SMD FAST |
| OP193FSZ-REEL7 | IC OPAMP GP 35KHZ PREC 8SOIC |
| 2070.0021.11 | FUSE OSU 250V 3.15A |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OP162HRU | 制造商:Analog Devices 功能描述: |
| OP162HRU-REEL | 制造商:Analog Devices 功能描述:OP Amp Single GP R-R O/P ±6V/12V 8-Pin TSSOP T/R 制造商:Rochester Electronics LLC 功能描述:15 MHZ RAIL-TO-RAIL OP AMP TAPE & REEL - Tape and Reel |
| OP162HRUZ-REEL | 制造商:Analog Devices 功能描述:OP Amp Single GP R-R O/P ±6V/12V 8-Pin TSSOP T/R |
| OP165 | 制造商:OPTEK 制造商全稱:OPTEK 功能描述:GAAS PLASTIC INFRARED EMITTING DIODE |
| OP165_06 | 制造商:OPTEK 制造商全稱:OPTEK 功能描述:Plastic Infrared Emitting Diode |
發布緊急采購，3分鐘左右您將得到回復。