TYPICAL CHARACTERISTICS
www.ti.com ............................................................................................................................................ SBOS342B – DECEMBER 2008 – REVISED AUGUST 2009
Table of Graphs
TITLE
FIGURE
Noninverting Small-Signal Frequency Response
VO = 200mVPP
Noninverting Large-Signal Frequency Response
VO = 2VPP
Noninverting Large-Signal Frequency Response
VO = 6VPP
Inverting Small-Signal Frequency Response
VO = 200mVPP
Inverting Large-Signal Frequency Response
VO = 2VPP
Inverting Large-Signal Frequency Response
VO = 6VPP
Noninverting Transient Response
0.5V Step
Noninverting Transient Response
2V Step
Noninverting Transient Response
5V Step
Inverting Transient Response
0.5V Step
Inverting Transient Response
2V Step
Inverting Transient Response
5V Step
Harmonic Distortion vs Frequency
Harmonic Distortion vs Noninverting Gain
Harmonic Distortion vs Inverting Gain
Harmonic Distortion vs Load Resistance
Harmonic Distortion vs Output Voltage
Harmonic Distortion vs ±Supply Voltage
Two-Tone, Second- and Third-Order Intermodulation Distortion vs Frequency
Overdrive Recovery
Gain = +2V/V
Overdrive Recovery
Gain = –2V/V
Input-Referred Voltage Spectral Noise Density
Common-Mode Rejection Ratio and Power-Supply Rejection Ratio vs Frequency
Recommended RISO vs Capacitive Load
Frequency Response vs Capacitive Load
Open-Loop Gain and Phase
Closed-Loop Output Impedance vs Frequency
Transimpedance Gain vs Frequency
CD = 10pF
Transimpedance Gain vs Frequency
CD = 22pF
Transimpedance Gain vs Frequency
CD = 47pF
Transimpedance Gain vs Frequency
CD = 100pF
Maximum/Minimum ±VOUT vs RLOAD
Slew Rate vs VOUT Step
Copyright 2008–2009, Texas Instruments Incorporated
5
Product Folder Link(s):
OPA659