- 您現在的位置：買賣IC網 > PDF目錄367727 > P87C770AAR (NXP SEMICONDUCTORS) Microcontrollers for NTSC TVs with On-Screen Display OSD and Closed Caption CC PDF資料下載
參數資料
| 型號： | P87C770AAR |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Microcontrollers for NTSC TVs with On-Screen Display OSD and Closed Caption CC |
| 中文描述： | 8-BIT, OTPROM, 12 MHz, MICROCONTROLLER, PDIP52 |
| 文件頁數： | 12/80頁 |
| 文件大小： | 266K |
| 代理商： | P87C770AAR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
1999 Jun 11
12
Philips Semiconductors
Product specification
Microcontrollers for NTSC TVs with On-Screen
Display (OSD) and Closed Caption (CC)
P8xCx70 family
9
REDUCED POWER MODES
In order to reduce power consumption three reduced
power modes are available: Standby, Idle and
Power-down.
9.1
Standby mode
In Standby mode full CPU functionality is available but all
analog functions (including the OSD) are disabled.
Power-on reset and the oscillator remain active.
The following also remain active during Standby mode.
CPU
External interrupts INT0 and INT1
T0, T1 and T3
I
2
C-bus interface
PWM outputs.
The Standby mode is entered by setting the STBY bit in
the STBCON register to a logic 1. Recovering from the
Standby mode is achieved by setting the STBY bit back to
a logic 0. After entering the normal mode a waiting time of
10
μ
s has to be taken into account in order to allow the
analog circuitry to stabilize.
9.2
Idle mode
Idle mode operation permits all functions to continue to
work with the exception that the CPU clock is halted.
The following functions remain active during Idle mode:
T0, T1 and T3 (Watchdog Timer)
I
2
C-bus
External interrupts.
9.2.1
E
NTERING
I
DLE MODE
The instruction that sets the IDL bit in the PCON register is
the last instruction executed before entering Idle mode.
Once in the Idle mode the system oscillator keeps running
but the internal clock is gated away from the CPU, but not
gated away from the interrupts, timers and serial port
functions. The CPU status is preserved along with the
Stack Pointer, Program Counter, Program Status Word
and Accumulator. The RAM and all other registers
maintain their data during Idle mode. The port pins retain
the logical states they were holding at Idle mode activation.
9.2.2
R
ECOVERING FROM
I
DLE MODE
There are two methods used to terminate the Idle mode.
Assertion of any enabled interrupt will cause the IDL bit to
be cleared by hardware, thus terminating the Idle mode.
The interrupt is serviced, and following the instruction
RETI, the next instruction to be executed will be the one
following the instruction that put the device into the Idle
mode.
Flag bits GF0 and GF1 may be used to determine whether
the interrupt was received during normal execution or
during Idle mode. For example, the instruction that writes
to the IDL bit can also set or clear one or both flag bits.
When Idle mode is terminated by an interrupt, the service
routine can examine the status of the flag bits.
The second method of terminating the Idle mode is with an
external hardware reset. Since the oscillator is still
running, the hardware reset is required to be active for only
two machine cycles to complete the reset operation. Reset
redefines all SFRs, but does not affect the on-chip RAM.
9.3
Power-down mode
The Power-down operation freezes the oscillator and all
on-chip operations stop. The Power-down mode can only
be entered if the EW bit in SFR BWC is LOW; then the
Power-down mode is entered by setting the PD bit in the
PCON register to a logic 1.
The instruction which sets the PD bit in PCON is the last
instruction executed prior to going into the Power-down
mode. The contents of the on-chip RAM and SFRs are
preserved. The port pins output the values held by their
respective SFRs.
In the Power-down mode V
DD
may be reduced to minimize
power consumption. However, the supply voltage must not
be reduced until Power-down mode is active, and must be
restored before the hardware reset is applied and frees the
oscillator. An on-chip delay counter will count 2048 system
oscillator cycles before enabling the internal clock.
9.3.1
W
AKE
-
UP FROM
P
OWER
-
DOWN USING EXTERNAL
INTERRUPTS
If either of the external interrupts INT0 and INT1 is
switched to level-sensitive and enabled then the interrupt
can be used to wake-up the P8xCx70 from the
Power-down mode. To ensure that the oscillator is stable
before the controller restarts, the internal clock will remain
inactive for 2048 system oscillator cycles.
9.3.2
W
AKE
-
UP FROM
P
OWER
-
DOWN USING
RESET
The Power-down mode can be terminated by holding the
RESET pin HIGH for two machine cycles, this clears the
PD bit. The on-chip delay counter will count 2048 system
oscillator cycles before enabling the internal clock.
相關PDF資料 |
PDF描述 |
|---|---|
| P83C270 | Microcontrollers for NTSC TVs with On-Screen Display (OSD) and Closed Caption (CC)(在NTSC TV中應用的具有屏幕顯示和字幕關閉特點的微控制器) |
| P83C370 | Microcontrollers for NTSC TVs with On-Screen Display (OSD) and Closed Caption (CC)(在NTSC TV中應用的具有屏幕顯示和字幕關閉特點的微控制器) |
| P87C770 | Microcontrollers for NTSC TVs with On-Screen Display (OSD) and Closed Caption (CC)(在NTSC TV中應用的具有屏幕顯示和字幕關閉特點的微控制器) |
| P83C270AAR | Microcontrollers for NTSC TVs with On-Screen Display OSD and Closed Caption CC |
| P83C434CFP | ECONOLINE: RU - Twin Independent Outputs- Output/Output Isolation 1kVDC- Power Sharing on Outputs- Input/Output Isolation 1kVDC- No Heatsink Required- UL94V-0 Package Material- Toroidal Magnetics- No Extern. Components Required- Custom Solutions Available- Efficiency t |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P87L42 | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:UNIVERSAL PERIPHERAL INTERFACE CHMOS 8-BIT SLAVE MICROCONTROLLER |
| P87LPC759 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count (14 pin) microcontroller with 1 kbyte OTP |
| P87LPC759BN | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count (14 pin) microcontroller with 1 kbyte OTP |
| P87LPC760 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low power, low price, low pin count (14 pin) microcontroller with 1 kbyte OTP |
| P87LPC760BDH | 功能描述:8位微控制器 -MCU 80C51 1K/128 OTP RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。