參數資料
型號： PCA9553D
廠商： NXP Semiconductors N.V.
元件分類： LED驅動器
英文描述： 4-bit I2C-bus LED driver with programmable blink rates
封裝： PCA9553D/01<SOT96-1 (SO8)|<<http://www.nxp.com/packages/SOT96-1.html<1<week 5, 2005,;PCA9553D/01<SOT96-1 (SO8)|<<http://www.nxp.com/packages/SOT96-1.html<1<week 5,
文件頁數： 1/26頁
文件大?。?/td> 146K
代理商： PCA9553D
1.
General description
The PCA9553 LED blinker blinks LEDs in I2C-bus and SMBus applications where it is
necessary to limit bus trafc or free up the I2C-bus master's (MCU, MPU, DSP, chip set,
etc.) timer. The uniqueness of this device is the internal oscillator with two programmable
blink rates. To blink LEDs using normal I/O expanders like the PCF8574 or PCA9554, the
bus master must send repeated commands to turn the LED on and off. This greatly
increases the amount of trafc on the I2C-bus and uses up one of the master's timers. The
PCA9553 LED blinker instead requires only the initial set-up command to program
BLINK RATE 1 and BLINK RATE 2 (i.e., the frequency and duty cycle). From then on, only
one command from the bus master is required to turn each individual open-drain output
ON, OFF, or to cycle at BLINK RATE 1 or BLINK RATE 2. Maximum output sink current is
25 mA per bit and 100 mA per package.
Any bits not used for controlling the LEDs can be used for General Purpose Parallel
Input/Output (GPIO) expansion.
Power-On Reset (POR) initializes the registers to their default state, all zeroes, causing
the bits to be set HIGH (LED off).
Due to pin limitations, the PCA9553 is not featured with hardware address pins. The
PCA9553/01 and the PCA9553/02 have different xed I2C-bus addresses allowing
operation of both on the same bus.
2.
Features
I 4 LED drivers (on, off, ashing at a programmable rate)
I 2 selectable, fully programmable blink rates (frequency and duty cycle) between
0.172 Hz and 44 Hz (5.82 seconds and 0.023 seconds)
I Input/outputs not used as LED drivers can be used as regular GPIOs
I Internal oscillator requires no external components
I I2C-bus interface logic compatible with SMBus
I Internal power-on reset
I Noise lter on SCL/SDA inputs
I 4 open-drain outputs directly drive LEDs to 25 mA
I Controlled edge rates to minimize ground bounce
I No glitch on power-up
I Supports hot insertion
I Low standby current
I Operating power supply voltage range of 2.3 V to 5.5 V
I 0 Hz to 400 kHz clock frequency
PCA9553
4-bit I2C-bus LED driver with programmable blink rates
Rev. 06 — 29 December 2008
Product data sheet
相關PDF資料
PDF描述
PCB25 POWER CONNECTOR
PCF8578T LCD row-column driver for dot matrix graphic displays
PCI-36RS-SB-L STRAIGHT TELECOM AND DATACOM CONNECTOR
PCI-36SS-SB-N STRAIGHT TELECOM AND DATACOM CONNECTOR
PCI-36SS-B-H STRAIGHT TELECOM AND DATACOM CONNECTOR
相關代理商/技術參數
參數描述
PCA9553D/01 功能描述:LED照明驅動器 LED DRVR 4BIT I2C RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
PCA9553D/01,112 功能描述:LED照明驅動器 LED DRVR 4BIT I2C RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
PCA9553D/01,118 功能描述:LED照明驅動器 4-BIT I2C FM OD LED BLK RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
PCA9553D/01112 制造商:Rochester Electronics LLC 功能描述: 制造商:NXP 功能描述: 制造商:NXP Semiconductors 功能描述:
PCA9553D/02 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:4-bit I2C-bus LED driver with programmable blink rates
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*