
PEB 80900
Overview
Data Sheet
11
2001-04-02
1.6
Editorial Changes between the IEC-T Target Specification [2]
and Part II
’
IEC-T
’
of the NTC-AM Data Sheet
“
Part II
’
IEC-T
’
: General Description
”
on Page 69
Removed:
’
At present, the IEC is available in a two chip set only.
’
“
Basic System Functions
”
on Page 70
Removed:
’
Low power consumption:
Standby:max. 20 mW
Active:max. 250 mW
’
Removed:
’
40 pin DIL package or 44 pin PLCC package.
’
Reworked pin configuration
“
Related Documents
”
on Page 73
The following documents have been removed from the list
’
Related Documents
’
:
Technische Lieferbedingungen 163 TL 31 f
ü
r digitale Fernsprechvermittlungstechnik
EWSD/0
Technische Lieferbedingungen 163 TL 311 f
ü
r die Anpassung EWSD/0 an ISDN
Technische Lieferbedingungen Basisanschluss-Multiplexger
t (BAMX)
FTZ-Richtlinie 1 TR 211, Speisekonzept f
ü
r den Basisanschluss
FTZ-Richtlinie 1 TR 212, Pr
ü
fen und Messen von digitalen Anschl
ü
ssen
IC's for Telecommunications, IOM
-ISDN oriented Modular Interface Edition 5.86
The documentation for ICC and SBC is updated.
“
IOM
Concept and Applications of the IEC
”
on Page 75
According to the Delta Sheet IEC-T/D PEB 20901 Version 5.1, the IOM-2 mode is not
functional in any version of PEB 20901. Therefore, the whole part II of this document
refers only to IOM-1 mode.
“
Interfaces
”
on Page 78
Updated pinning in all figures and table.
“
Mode Dependent Functions
”
on Page 88
Removed all IOM-2 modes
“
Data and Clocks in NT, NT-RP, NT-TE1 Mode
”
on Page 90
CLS output: .
“
Suggestion for the Generation of the Master Clock in the Repeater
”
on Page 103
Reworked figure for NTC-T AM.
“
Remote Control of Loop 4 and Loop 2 by the NTC-T AM with IEC-T Functionality
Selected
”
on Page 107
NT, NT-RP: 7.68 MHz clock, synchronized to received data
on Uk0.
NT-TE1: 1.536 MHz, synchronized to received data on Uk0.