- 您現在的位置：買賣IC網 > PDF目錄368145 > PSD303R Field Programmable Microcontroller Peripherals(可編程邏輯,無SRAM,19個可編程I/O,通用PLD有16個輸入) PDF資料下載
參數資料
| 型號： | PSD303R |
| 英文描述： | Field Programmable Microcontroller Peripherals(可編程邏輯,無SRAM,19個可編程I/O,通用PLD有16個輸入) |
| 中文描述： | 現場可編程微控制器外圍設備（可編程邏輯，無的SRAM，19余個可編程輸入/輸出，通用PLD的有16個輸入） |
| 文件頁數： | 32/127頁 |
| 文件大?。?/td> | 682K |
| 代理商： | PSD303R |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁
PSD3XX Famly
2-32
Security Mode in the PSD3XX locks the contents of the PAD A , PAD B and all the
configuration bits. The EPROM, SRAM, and I/O contents can be accessed only through
the PAD. The Security Mode can be set by the PSD Development or Programming
software. In window packages, the mode is erasable through UV full part erasure. In the
security mode, the PSD3XX contents cannot be copied on a programmer.
Symbol
Parameter
Condition
CERDIP
PLASTIC
With Respect to GND
Min
– 65
– 65
– 0.6
Max
+ 150
+ 125
+ 7
Unit
°C
°C
V
T
STG
Storage Temperature
Voltage on any Pin
Programming
Supply Voltage
V
PP
With Respect to GND
– 0.6
+ 14
V
V
CC
Supply Voltage
With Respect to GND
– 0.6
>
2000
+ 7
V
ESD Protection
V
Range
Temperature
V
CC
V
CC
Tolerance
Commercial
Industrial
Military
0° C to +70°C
–40° C to +85°C
–55° C to +125°C
+ 5 V
+ 5 V
+ 5 V
± 10%
± 10%
± 10%
Symbol
Parameter
Conditions
Min
Typ
Max Unit
V
CC
Supply Voltage
All Speeds
4.5
5
5.5
V
V
CC
Supply Voltage
PSD3XXL Versions Only,
All Speeds
3.0
3.3
5.5
V
The EPROM power consumption in the PSD is controlled by bit 3 in the PMMR0 – EPROM
CMiser. Upon reset the CMiser bit is OFF. This will cause the EPROM to be ON at all times
as long as CSI is enabled (low). The reason this mode is provided is to reduce the access
time of the EPROM by 10 ns relative to the low power condition when CMiser is ON.
If CSI is disabled (high) the EPROM will be deselected and will enter standby mode (OFF)
overriding the state of the CMiser.
If CMiser is set (ON) then the EPROM will enter the standby mode when not selected.
This condition can take place when CSI is high or when CSI is low and the EPROM is not
accessed. For example, if the MCU is accessing the SRAM, the EPROM will be
deselected and will be in low power mode.
An additional advantage of the CMiser is achieved when the PSD is configured in the by 8
mode (8 bit data bus). In this case an additional power savings is achieved in the EPROM
(and also in the SRAM) by turning off 1/2 of the array even when the EPROM is accessed
(the array is divided internally into odd and even arrays).
The power consumption for the different EPROM modes is given in the DC Characteristics
table under I
CC
(DC) EPROM Adder.
Security
Mode
EPROM
Absolute
Maximum
Ratings
26
Operating
Range
Recommended
Operating
Conditions
NOTE:
26.Stresses above those listed under Absolute Maximum Ratings may cause permanent
damage to the device. This is a stress rating only and functional operation of the device at
these or any other conditions above those indicated in the operational sections of this
specification is not implied. Exposure to Absolute Maximum Rating conditions for
extended periods of time may affect device reliability.
相關PDF資料 |
PDF描述 |
|---|---|
| PSD304RL | Field Programmable Microcontroller Peripherals(可編程邏輯,無SRAM,19個可編程I/O,通用PLD有16個輸入) |
| PSD312L | Field Programmable Microcontroller Peripherals(可編程邏輯,16K位SRAM,4位頁寄存器,19個可編程I/O,通用PLD有16個輸入) |
| PSD312R | Field Programmable Microcontroller Peripherals(可編程邏輯,無SRAM,4位頁寄存器,19個可編程I/O,通用PLD有16個輸入) |
| PSD313L | Field Programmable Microcontroller Peripherals(可編程邏輯,16K位SRAM,19個可編程I/O,通用PLD有16個輸入) |
| PSD314RL | Field Programmable Microcontroller Peripherals(可編程邏輯,無SRAM,19個可編程I/O,通用PLD有16個輸入) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSD303R-15J | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low Cost Field Programmable Microcontroller Peripherals |
| PSD303R-15JI | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low Cost Field Programmable Microcontroller Peripherals |
| PSD303R-15JM | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low Cost Field Programmable Microcontroller Peripherals |
| PSD303R-20J | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low Cost Field Programmable Microcontroller Peripherals |
| PSD303R-20JI | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low Cost Field Programmable Microcontroller Peripherals |
發布緊急采購，3分鐘左右您將得到回復。