參數資料
型號： S1D2518X01
廠商： SAMSUNG SEMICONDUCTOR CO. LTD.
元件分類： 視頻放大器
英文描述： DB25 RJ11,4 WIRE ONLY. FEMAL
中文描述： 的I2C總線控制轉/克/乙視頻放大器
文件頁數： 15/38頁
文件大?。?/td> 457K
代理商： S1D2518X01
S1D2518X01 I
2
C BUS CONTROLLED R/G/B VIDEO AMPLIFIER FOR MONITORS
14
Preliminary
NOTES:
1.
2.
For guaranteed specifications and test conditions, see the electrical characteristics. The guaranteed specifications apply
only for the test conditions listed. Some performance characteristics may degrade when the device is not operated under
the listed test conditions.
3.
V
CC
supply pins 6, and 25 must be externally wired together to prevent internal damage during V
CC
power on/off
cycles.
4.
The supply current specified is the quiescent current for VCC
1
/VCC
2
and VCC3 with RL =
∞
, The supply current
for VCC2 (pin 25) also depends on the output load.
5.
Output voltage is dependent on load resistor. Test circuit uses RL = 390
6.
Measure gain difference between any two amplifiers Vin = 560mVpp.
7.
When measuring video amplifier bandwidth or pulse rise and fall times, a double sided full ground plane printed circuit
board without socket is recommended. Video amplifier 10MHz isolation test also requires this printed circuit board. The
reason for a double sided full ground plane PCB is that large measurement variations occur in single sided PCBs.
8.
Adjust input frequency from 10MHz (AV max reference level) to the-3dB frequency (f -3dB).
9.
Measure output levels of the other two undriven amplifiers relative to the driven amplifier to determine channel separation.
Terminate the undriven amplifier inputs to simulate generator loading. Repeat test at fin = 10MHz for Iso_10MHz.
10. A minimum pulse width of 200 ns is guaranteed for a horizontal line of 15kHz. This limit is guaranteed by design. if a lower
line rate is used a longer clamp pulse may be required.
11. During the AC test the 4V DC level is the center voltage of the AC output signal. For example. If the output is 4Vpp the
signal will swing between 2V DC and 6V DC.
12. These parameters are not tested on each product which is controlled by an internal qualification procedure.
Absolute maximum rating indicates the limit beyond which damage to the device may occur.
Operating ratings indicate conditions for which the device is functional but do not guarantee specific performance limits.
相關PDF資料
PDF描述
S1L9226X RF AMP & SERVO SIGNAL PROCESSOR
S1L9226X01-Q0R0 RF AMP & SERVO SIGNAL PROCESSOR
S1L9251X CD-ROM 48X RF AMP
S1M8662A CDMA/PCS/GPS Triple Mode IF/ baseband IC
S1M8662AX01-F0T0 CDMA/PCS/GPS Triple Mode IF/ baseband IC
相關代理商/技術參數
參數描述
S-1-D-2-D 制造商:Interconnect Devices Inc (IDI) 功能描述:SPRING CONTACT PROBE
S-1-D-2-D D/C .670 OAL 功能描述:觸點探頭 HEADED RADIUS RoHS:否 制造商:IDI 類型:Probes 尖端類型:Spherical Radius 長度:8.26 mm 電流額定值:10 A 彈力:2.3 oz 行程:1.52 mm 系列:101050
S-1-D-2-G 制造商:Interconnect Devices Inc (IDI) 功能描述:connectors
S-1-D-2-G D/C .670 OAL 功能描述:觸點探頭 HEADED RADIUS RoHS:否 制造商:IDI 類型:Probes 尖端類型:Spherical Radius 長度:8.26 mm 電流額定值:10 A 彈力:2.3 oz 行程:1.52 mm 系列:101050
S-1-D-3.8-D D/C .670 OAL 功能描述:觸點探頭 HEADED RADIUS RoHS:否 制造商:IDI 類型:Probes 尖端類型:Spherical Radius 長度:8.26 mm 電流額定值:10 A 彈力:2.3 oz 行程:1.52 mm 系列:101050
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*