參數資料
型號: SAK-C167CS-4R40M-BA
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 40 MHz, MICROCONTROLLER, PQFP144
封裝: METRIC, PLASTIC, QFP-144
文件頁數: 20/72頁
文件大?。?/td> 1254K
代理商: SAK-C167CS-4R40M-BA
C167CS-4R
C167CS-L
Data Sheet
23
V2.2, 2001-08
Capture/Compare (CAPCOM) Units
The CAPCOM units support generation and control of timing sequences on up to
32 channels with a maximum resolution of 16 TCL. The CAPCOM units are typically
used to handle high speed I/O tasks such as pulse and waveform generation, pulse
width modulation (PMW), Digital to Analog (D/A) conversion, software timing, or time
recording relative to external events.
Four 16-bit timers (T0/T1, T7/T8) with reload registers provide two independent time
bases for the capture/compare register array.
The input clock for the timers is programmable to several prescaled values of the internal
system clock, or may be derived from an overflow/underflow of timer T6 in module GPT2.
This provides a wide range of variation for the timer period and resolution and allows
precise adjustments to the application specific requirements. In addition, external count
inputs for CAPCOM timers T0 and T7 allow event scheduling for the capture/compare
registers relative to external events.
Both of the two capture/compare register arrays contain 16 dual purpose capture/
compare registers, each of which may be individually allocated to either CAPCOM timer
T0 or T1 (T7 or T8, respectively), and programmed for capture or compare function.
Each register has one port pin associated with it which serves as an input pin for
triggering the capture function, or as an output pin to indicate the occurrence of a
compare event.
When a capture/compare register has been selected for capture mode, the current
contents of the allocated timer will be latched (‘capture’d) into the capture/compare
register in response to an external event at the port pin which is associated with this
register. In addition, a specific interrupt request for this capture/compare register is
generated. Either a positive, a negative, or both a positive and a negative external signal
transition at the pin can be selected as the triggering event. The contents of all registers
which have been selected for one of the five compare modes are continuously compared
with the contents of the allocated timers. When a match occurs between the timer value
and the value in a capture/compare register, specific actions will be taken based on the
selected compare mode.
相關PDF資料
PDF描述
SAK-C167CS-4RC 16-BIT, MROM, 33 MHz, MICROCONTROLLER, UUC146
SAK-C167CS-LC 16-BIT, MROM, 33 MHz, MICROCONTROLLER, UUC146
SAL-C167CS-L33C 16-BIT, MROM, 33 MHz, MICROCONTROLLER, UUC146
SAK-C504-L40M 8-BIT, 20 MHz, MICROCONTROLLER, PQFP44
SAK-C509-LM 8-BIT, 16 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
SAK-C167CS-4RM 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontroller
SAK-C167CS-L33M 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Infineon Technologies AG 功能描述:
SAK-C167CS-L33M CA+ 功能描述:16位微控制器 - MCU 16BIT SNGL CHIP 5V 33MHz ROM less RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-C167CS-L33M-CA 制造商:Infineon Technologies AG 功能描述:
SAKC167CSL33MCA+ 制造商:Infineon Technologies AG 功能描述: