參數資料
型號： SC16C752BIB48,151
廠商： NXP Semiconductors
文件頁數： 8/47頁
文件大?。?/td> 0K
描述： IC DUAL UART 64BYTE 48LQFP
標準包裝： 250
通道數： 2，DUART
FIFO's： 64 字節
電源電壓： 2.5V，3.3V，5V
帶自動流量控制功能： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
安裝類型： 表面貼裝
封裝/外殼： 48-LQFP
供應商設備封裝： 48-LQFP（7x7）
包裝： 托盤
其它名稱： 935274411151
SC16C752BIB48-S
SC16C752BIB48-S-ND
SC16C752B
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 6 — 30 November 2010
16 of 47
NXP Semiconductors
SC16C752B
5 V, 2.2 V and 2.5 V dual UART, 5 Mbit/s (max.), with 64-byte FIFOs
6.6.2 Block DMA transfers (DMA mode 1)
Figure 11 shows TXRDYn and RXRDYn in DMA mode 1.
6.6.2.1
Transmitter
TXRDYn is active when there is a trigger level number of spaces available. It becomes
inactive when the FIFO is full.
6.6.2.2
Receiver
RXRDYn becomes active when the trigger level has been reached, or when a time-out
interrupt occurs. It will go inactive when the FIFO is empty or an error in the receive FIFO
is flagged by LSR[7].
6.7 Sleep mode
Sleep mode is an enhanced feature of the SC16C752B UART. It is enabled when EFR[4],
the enhanced functions bit, is set and when IER[4] is set. Sleep mode is entered when:
The serial data input line, RXn, is idle (see Section 6.8 “Break and time-out
The transmit FIFO and transmit shift register are empty.
There are no interrupts pending except THR and time-out interrupts.
Remark: Sleep mode will not be entered if there is data in the receive FIFO.
In Sleep mode, the UART clock and baud rate clock are stopped. Since most registers are
clocked using these clocks, the power consumption is greatly reduced. The UART will
wake up when any change is detected on the RXn line, when there is any change in the
state of the modem input pins, or if data is written to the transmit FIFO.
Remark: Writing to the divisor latches DLL and DLM to set the baud clock must not be
done during Sleep mode. Therefore, it is advisable to disable Sleep mode using IER[4]
before writing to DLL or DLM.
Fig 11. TXRDYn and RXRDYn in DMA mode 1
transmit
wrptr
TXRDYn
FIFO full
TXRDYn
receive
rdptr
FIFO EMPTY
RXRDYn
002aaa234
trigger
level
trigger
level
at least one
location filled
相關PDF資料
PDF描述
SC16C752BIB48,157 IC UART DUAL W/FIFO 48-LQFP
SC16C752BIB48,128 IC DUAL UART 64BYTE 48LQFP
SC16IS762IPW,112 IC DUAL UART 64BYTE 28TSSOP
ATMEGA168PV-10AUR MCU AVR 16KB FLASH 10MHZ 32TQFP
FT4232HL-REEL IC USB HS QUAD UART/SYNC 64-LQFP
相關代理商/技術參數
參數描述
SC16C752BIB48-F 功能描述:UART 接口集成電路 16CB 2.5V-5V 2CH UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C752BIB48-S 功能描述:UART 接口集成電路 16CB 2.5V-5V 2CH UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C752BIBS 功能描述:UART 接口集成電路 16CB 2.5V-5V 2CH UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C752BIBS,128 功能描述:UART 接口集成電路 16CB 2.5V-5V 2CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C752BIBS,151 功能描述:UART 接口集成電路 2CH. UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*