- 您現在的位置：買賣IC網 > PDF目錄1967 > SC5554MVR132 (Freescale Semiconductor)MCU MPC5554 DP ONLY 416-PBGA PDF資料下載
參數資料
| 型號： | SC5554MVR132 |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 2/58頁 |
| 文件大?。?/td> | 0K |
| 描述： | MCU MPC5554 DP ONLY 416-PBGA |
| 標準包裝： | 200 |
| 系列： | MPC55xx Qorivva |
| 核心處理器： | e200z6 |
| 芯體尺寸： | 32-位 |
| 速度： | 132MHz |
| 連通性： | CAN，EBI/EMI，SCI，SPI |
| 外圍設備： | DMA，POR，PWM，WDT |
| 輸入/輸出數： | 256 |
| 程序存儲器容量： | 2MB（2M x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 64K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.35 V ~ 1.65 V |
| 數據轉換器： | A/D 40x12b |
| 振蕩器型： | 外部 |
| 工作溫度： | -40°C ~ 125°C |
| 封裝/外殼： | 416-TBGA |
| 包裝： | 托盤 |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁
MPC5554 Microcontroller Data Sheet, Rev. 4
Electrical Characteristics
Freescale Semiconductor
10
3.7
Power-Up/Down Sequencing
Power sequencing between the 1.5 V power supply and VDDSYN or the RESET power supplies is required
if using an external 1.5 V power supply with VRC33 tied to ground (GND). To avoid power-sequencing,
VRC33 must be powered up within the specified operating range, even if the on-chip voltage regulator
controller is not used. Refer to Section 3.7.2, “Power-Up Sequence (VRC33 Grounded),” and
Power sequencing requires that VDD33 must reach a certain voltage where the values are read as ones
before the POR signal negates. Refer to Section 3.7.1, “Input Value of Pins During POR Dependent on
Although power sequencing is not required between VRC33 and VDDSYN during power up, VRC33 must
not lead VDDSYN by more than 600 mV or lag by more than 100 mV for the VRC stage turn-on to operate
within specification. Higher spikes in the emitter current of the pass transistor occur if VRC33 leads or lags
VDDSYN by more than these amounts. The value of that higher spike in current depends on the board power
supply circuitry and the amount of board level capacitance.
8
Voltage differential during power up such that:
VDD33 can lag VDDSYN or VDDEH6 before VDDSYN and VDDEH6 reach the
VPOR33 and VPOR5 minimums respectively.
VDD33_LAG
—1.0
V
9
Absolute value of slew rate on power supply pins
—
50
V/ms
10
Required gain at Tj:
IDD IVRCCTL (@ fsys = fMAX)
BETA11
70
—
– 40o C70
—
——
150o C
10511
500
—
1 The internal POR signals are V
POR15, VPOR33, and VPOR5. On power up, assert RESET before the internal POR negates.
RESET must remain asserted until the power supplies are within the operating conditions as specified in Table 9 DC Electrical
Specifications. On power down, assert RESET before any power supplies fall outside the operating conditions and until the
internal POR asserts.
2 V
3 Supply full operating current for the 1.5 V supply when the 3.3 V supply reaches this range.
4 It is possible to reach the current limit during ramp up—do not treat this event as short circuit current.
5 At peak current for device.
6 Requires compliance with Freescale’s recommended board requirements and transistor recommendations. Board signal
traces/routing from the VRCCTL package signal to the base of the external pass transistor and between the emitter of the pass
transistor to the VDD package signals must have a maximum of 100 nH inductance and minimal resistance
(less than 1
). V
RCCTL must have a nominal 1 F phase compensation capacitor to ground. VDD must have a 20 F (nominal)
bulk capacitor (greater than 4
F over all conditions, including lifetime). Place high-frequency bypass capacitors consisting of
eight 0.01
F, two 0.1 F, and one 1 F capacitors around the package on the V
DD supply signals.
7 Only available on devices that support -55o C.
8 I
VRCCTL is measured at the following conditions: VDD = 1.35 V, VRC33 = 3.1 V, VVRCCTL = 2.2 V.
9 Refer to Table 1 for the maximum operating frequency.
10 Values are based on I
DD from high-use applications as explained in the IDD Electrical Specification.
11 BETA represents the worst-case external transistor. It is measured on a per-part basis and calculated as (I
DD IVRCCTL).
Table 6. VRC and POR Electrical Specifications (continued)
Spec
Characteristic
Symbol
Min.
Max.
Units
相關PDF資料 |
PDF描述 |
|---|---|
| SCC2681AE1A44,529 | IC UART DUAL 44-PLCC |
| SCC2691AC1N24,129 | IC UART 24-DIP |
| SCC2692AC1N28,602 | IC DUART 28-DIP |
| SCC2698BC1A84,512 | IC UART OCTAL ENHANCED 84-PLCC |
| SCC68681C1N40,112 | IC DUART 40DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC5554MZP112 | 制造商:Freescale Semiconductor 功能描述:MPC5554, 84M68C, DP ONLY - Trays |
| SC5554MZP112R2 | 制造商:Freescale Semiconductor 功能描述:MPC5554, 84M68C, DP ONLY - Tape and Reel |
| SC5554MZP132 | 制造商:Freescale Semiconductor 功能描述:32-BIT MPC55XX POWERPC RISC 2MB FLASH 1.8V/2.5V/3.3V/5V 416 - Trays |
| SC5554MZP132R2 | 制造商:Freescale Semiconductor 功能描述:MPC5554, 84M68C, DP ONLY - Tape and Reel |
| SC5565MVZ132 | 制造商:Freescale Semiconductor 功能描述:2MB FLASH W/ECC, 3 CANS - Trays |
發布緊急采購，3分鐘左右您將得到回復。