- 您現在的位置：買賣IC網 > PDF目錄16517 > SI2401FS08-EVB (Silicon Laboratories Inc)BOARD EVAL SI2401 + SI3008 PDF資料下載
參數資料
| 型號： | SI2401FS08-EVB |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 21/76頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL SI2401 + SI3008 |
| 標準包裝： | 1 |
| 系列： | ISOmodem® |
| 主要目的： | 電信，數據采集裝置（DAA） |
| 已用 IC / 零件： | SI2401 |
| 已供物品： | 板，CD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁
Si2401
28
Rev. 1.0
send the first SIA block after the “c” is received. Once
the block is transmitted, the modem can monitor for the
acknowledge
tone
by
completing
the
following
sequence:
1. Place the Si2401 in command mode by pulsing the
ESCAPE pin (Si2401 pin 14). The “+++” and “ninth-
bit” escape modes operate in the “!2” mode but are
not recommended because they can send unwanted
characters to the remote modem.
2. Issue the “ATX1” command to turn the modem
transmitter off and begin monitoring for the
acknowledgment tones.
3. Monitor for a positive (negative) acknowledgment “P”
(“N”) after the tone has been detected for at least
400 ms.
4. The modem, still in command mode, can be placed
online as a transmitter by issuing the “ATX2”
command or a receiver by issuing the “ATX3”
command. If tonal acknowledgement is not used, the
host can toggle the ESCAPE pin to place the Si2401
in the command mode and issue an “ATX2” or an
“ATX3” command to reverse data direction.
This sequence can be repeated for long messages.
5.5. Modem Result Codes and Call
Progress
Table 14 shows the modem result codes that can be
used in call progress monitoring. All result codes are a
single character to speed up communication and ease
host processing.
Table 14. Modem Result Codes
Command
Function
a
British Telecom Caller ID Idle Tone
Alert Detected
b
Busy Tone Detected
c
Connect
d
Connect 1200 bps (when pro-
grammed as V.22bis modem)
f
Hookswitch Flash or Battery Reversal
Detected
H
Modem Automatically Hanging Up in
!2, !1
I
Intrusion Completed (parallel phone
back on-hook)
i
Intrusion Detected (parallel phone off-
hook on the line)
K
Kissoff Tone Detected
k
Contact ID Kissoff Tone too long (!1)
L
Phone Line Detected
l
No Phone Line Detected
m
Caller ID Mark Signal Detected
NNo Carrier Detected
n
No Dial tone (time-out set by CW
[S02])
O
Modem OK Response
R
Incoming Ring Signal Detected
r
Ringback Tone Detected
t
Dial Tone
v
Connect 75 bps TX (V.23 originate
only)
x
Overcurrent State Detected After an
Off-Hook Event
^
Kissoff tone detection required
,
Dialing Complete
相關PDF資料 |
PDF描述 |
|---|---|
| 1-6374518-0 | C/A LC TO LC 900UM BUF 10 SM |
| EYM15DTKN-S288 | CONN EDGECARD 30POS .156 EXTEND |
| REC5-4815DRWZ/H6/C | CONV DC/DC 5W 18-72VIN +/-15VOUT |
| A3DDB-2418M | IDC CABLE- AKR24B/AE24M/AKR24B |
| VI-JVX-EZ-S | CONVERTER MOD DC/DC 5.2V 25W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI2401FS10-EVB | 功能描述:網絡開發工具 SI2401+SI3010 ISO MODEM EVAL. BOARD RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| SI2401-FSR | 功能描述:電信線路管理 IC 2400b/s System Side 3rd Gen DAA Tech RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| SI2401URT-EVB | 功能描述:網絡開發工具 U 634-SI2401FS10-EVB RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| SI2403 | 制造商:SILABS 制造商全稱:SILABS 功能描述:V.22BIS ISOMODEM CHIPSET WITH ERROR CORRECTION |
| SI2403-FT | 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET ISOMODEM 2.4KBPS 24TSSOP - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。