- 您現在的位置：買賣IC網 > PDF目錄10906 > SI2439-A-GM (Silicon Laboratories Inc)IC ISOMODEM 33.6KBPS 38-QFN PDF資料下載
參數資料
| 型號： | SI2439-A-GM |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 14/70頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ISOMODEM 33.6KBPS 38-QFN |
| 標準包裝： | 364 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁
Si2494/39
Rev. 1.0
21
4.8. Low-Power Modes
The Si2494/39 provides multiple low power modes. Using the S24 S-register, the Si2494/39 can be set to
automatically enter sleep mode after a pre-programmed time of inactivity with either the DTE or the remote
modem. The sleep mode is entered after (S24) seconds have passed since the last DTE activity, after the transmit
FIFO is empty, and after the last data are received from the remote modem.
Additionally, the Si2494/39 can be placed in wake-on-ring-mode using the command, AT&Z. In either mode, the
ISOmodem remains in the sleep state until one of the following occurs:
A 1-to-0 transition on TXD (UART mode).
A 1-to-0 transition on SS (SPI mode).
A 1-to-0 transition on CS (parallel mode).
An incoming ring is detected.
A parallel telephone is picked up.
Line polarity reversal
The Si2494/39 may also be placed in a complete powerdown mode. Once the Si2494/39 completely powers down,
it can only be powered back on via the RESET pin.
4.9. Data Compression
The modem can achieve DTE (host-to-ISOmodem) speeds greater than the maximum DCE (modem-to-modem)
speed through the use of a data compression protocol. The compression protocols available are the ITU-T V.44,
V.42bis, and MNP5 protocols. Data compression attempts to increase throughput by compressing the data before
actually sending it. Thus, the modem is able to transmit more data in a given period of time.
4.10. Error Correction
The Si2494/39 ISOmodem can employ error correction (reliable) protocols to ensure error-free delivery of
asynchronous data sent between the host and the remote end. The Si2494/39 supports V.42 and MNP2-4 error
correction protocols. V.42 (LAPM) is most commonly used and is enabled by default.
4.11. Wire Mode
Wire mode is used to communicate with standard non-error correcting modems. When optioned with \N3, the
Si2494/39 falls back to wire mode if it fails in an attempt to negotiate a V.42 link with the remote modem. Error
correction and data compression are not active in wire mode.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC16LC72A-04/SS | IC MCU OTP 2KX14 A/D PWM 28SSOP |
| PIC16C72A/JW | IC MCU OTP 2KX14 A/D PWM 28CDIP |
| PIC16C65B/JW | IC MCU EPROM 4KX14 PWM 40CDIP |
| SI2439-A-FM | IC ISOMODEM 33.6KBPS 38-QFN |
| PIC16C62B/JW | IC MCU EPROM 2KX14 PWM 28CDIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI2439-A-GMR | 制造商:Silicon Laboratories Inc 功能描述:33.6 KBPS ISOMODEM + VOICE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC ISOMODEM 33.6KBPS 38-QFN |
| SI2456 | 制造商:SILABS 制造商全稱:SILABS 功能描述:V.90, V.34, V.32BIS ISOMODEM⑩ WITH INTEGRATED GLOBAL DAA |
| SI2456-FT | 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET ISOMODEM 56KBPS 24TSSOP - Rail/Tube |
| SI2456-FT/REV F | 制造商:Silicon Laboratories Inc 功能描述:NOT RECOMMENDED FOR NEW DESIGNS, SEE SI2457-FT - Rail/Tube |
| Si2456-FTR | 制造商:Silicon Laboratories Inc 功能描述:MODEM CHIP CHIPSET ISOMODEM 56KBPS 24TSSOP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。