- 您現在的位置：買賣IC網 > PDF目錄16516 > SI3210MPPQX-EVB (Silicon Laboratories Inc)BOARD EVAL W/DISCRETE INTERFACE PDF資料下載
參數資料
| 型號： | SI3210MPPQX-EVB |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 74/148頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL W/DISCRETE INTERFACE |
| 標準包裝： | 1 |
| 系列： | ProSLIC® |
| 主要目的： | 接口，模擬前端（AFE） |
| 已用 IC / 零件： | Si3210 |
| 已供物品： | 板，CD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁當前第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁
Si3210/Si3211
Rev. 1.61
31
Not
Recommended
fo
r N
ew
D
esi
gn
s
2.1.2. Linefeed Architecture
The ProSLIC is a low-voltage CMOS device that uses
either an Si3201 linefeed interface IC or low-cost
external components to control the high voltages
required for subscriber line interfaces. Figure 17 is a
simplified illustration of the linefeed control loop circuit
for TIP or RING and the external components used.
The ProSLIC uses both voltage and current sensing to
control TIP and RING. DC and ac line voltages on TIP
and RING are measured through sense resistors RDC
and RAC. The ProSLIC uses linefeed transistors QP and
QN to drive TIP and RING. QDN isolates the high-voltage
base of QN from the ProSLIC.
The ProSLIC measures voltage at various nodes in
order to monitor the linefeed current. RDC, RSE, and
RBAT provide access to these measuring points. The
sense circuitry is calibrated on-chip to guarantee
measurement
accuracy
with
standard
external
component
tolerances.
See
Calibration" on page 36 for details.
2.1.3. Linefeed Operation States
The ProSLIC linefeed has eight states of operation as
shown in Table 23. The state of operation is controlled
using the Linefeed Control register (direct Register 64).
The open state turns off all currents into the external
bipolar transistors and can be used in the presence of
fault conditions on the line and to generate Open Switch
Intervals (OSIs). TIP and RING are effectively tri-stated
with a dc output impedance of about 150 k
.
The ProSLIC can also automatically enter the open
state if it detects excessive power being consumed in
the external bipolar transistors.
for more details.
In the forward active and reverse active states, linefeed
circuitry is on, and the audio signal paths are powered
down.
In the forward and reverse on-hook transmission states,
audio signal paths are powered up to provide data
transmission during an on-hook loop condition.
The TIP Open state turns off all control currents to the
external bipolar devices connected to TIP and provides
an active linefeed on RING for ground start operation.
The RING Open state provides similar operation with
the RING drivers off and TIP active.
The
ringing
state
drives
programmable
ringing
waveforms onto the line.
2.1.4. Loop Voltage and Current Monitoring
The ProSLIC continuously monitors the TIP and RING
voltages and external BJT currents. These values are
available in registers 78–89. Table 24 on page 33 lists
the values that are measured and their associated
registers. An internal A/D converter samples the
measured voltages and currents from the analog sense
circuitry and translates them into the digital domain. The
A/D updates the samples at a rate of 800 Hz. Two
derived values are also reported: loop voltage and loop
current. The loop voltage, VTIP –VRING, is reported as a
1-bit sign, 6-bit magnitude format. For ground start
operation, the reported value is the RING voltage. The
loop current, (IQ1 – IQ2 + IQ5 –IQ6)/2, is reported in a 1-
bit sign, 6-bit magnitude format. In RING open and TIP
open states, the loop current is reported as (IQ1 – IQ2) +
(IQ5 –IQ6).
相關PDF資料 |
PDF描述 |
|---|---|
| GCM18DTMD | CONN EDGECARD 36POS R/A .156 SLD |
| VI-J5X-EZ-S | CONVERTER MOD DC/DC 5.2V 25W |
| M1WXK-1636R | IDC CABLE - MPL16K/MC16M/X |
| SI3210MPPQ1-EVB | BOARD EVAL W/SI3201 INTERFACE |
| MCP130-270DI/TO | IC SUPERVISOR 2.70V LOW TO92 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI3210MPPT1-EVB | 功能描述:音頻 IC 開發工具 U 634-3210-PPQX-EVB RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| SI3210MPPTX-EVB | 功能描述:音頻 IC 開發工具 U 634-3210-PPQX-EVB RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| SI3210M-TSSOP | 制造商:SILABS 制造商全稱:SILABS 功能描述:Perfroms all BORSCHT functions DC-DC controller provides tracking battery fromm a 3.3-35V input |
| SI3210PPQ1-EVB | 功能描述:音頻 IC 開發工具 Si3210 QFN Eval Board RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| SI3210-PPQX-EVB | 制造商:Silicon Laboratories Inc 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。