- 您現在的位置：買賣IC網 > PDF目錄16214 > SI3232PPTX-EVB (Silicon Laboratories Inc)BOARD EVAL W/DISCRETE INTERFACE PDF資料下載
參數資料
| 型號： | SI3232PPTX-EVB |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 57/128頁 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL W/DISCRETE INTERFACE |
| 標準包裝： | 1 |
| 系列： | ProSLIC® |
| 主要目的： | 接口，模擬前端（AFE） |
| 已用 IC / 零件： | Si3232 |
| 已供物品： | 板，CD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
Si3232
34
Preliminary Rev. 0.96
Not
Recommended
fo
r N
ew
D
esi
s
4.5.2. Ground Key Detection
Ground key detection detects an alerting signal from the
terminal equipment during the tip open or ring open
linefeed states. The functional blocks required to
implement a ground key detector are shown in
Figure 15, and the register set for detecting a ground
key event is provided in Table 22 on page 36. The
primary input to the system is the longitudinal current
sense value provided by the voltage/current/power
monitoring circuitry and reported in the ILONG RAM
address. The ILONG value is produced in the ISP
provided the LFS bits in the linefeed register indicate
the device is in the tip open or ring open state.
The longitudinal current (ILONG) is computed as shown
in the following equation. Refer to Figure 11 on page 26
for the transistor references used in the equation (Q1,
Q2,
Q5
and
Q6
–
note
that
the
Si3200
has
corresponding MOS transistors). The same ILONG
equation applies to the discrete bipolar linefeed as well
as the Si3200 linefeed device.
The output of the ISP (ILONG) is the input to a
programmable, digital low-pass filter, which removes
unwanted ac signal components before threshold
detection.
The low-pass filter coefficient is calculated using the
following equation and is entered into the LONGLPF
RAM location:
Where f = the desired cutoff frequency of the filter.
The programmable range of the filter is from 0h (blocks
all signals) to 4000h (unfiltered). A typical value of 10
(0A10h) is sufficient to filter out any unwanted ac
artifacts while allowing the dc information to pass
through the filter.
The output of the low-pass filter is compared to the
programmable threshold, LONGHITH. Hysteresis is
enabled
by
programming
a
second
threshold,
LONGLOTH, to detect when the ground key is released.
The threshold comparator output feeds a programmable
debounce filter.
The output of the debounce filter remains in its present
state unless the input remains in the opposite state for
the entire period of time programmed by the loop
closure debounce interval, LONGDBI. If the debounce
interval is satisfied, the LONGHI bit is set to indicate
that a valid ground key event has occurred.
When the Si3220/25 detects a ground key event, the
linefeed automatically transitions from the TIP-OPEN
(or RING-OPEN) state to the FORWARD-ACTIVE (or
REVERSE-ACTIVE) state. However, this automatic
state transition is triggered by the LCR bit becoming
active (i.e., =1), and not by the LONGHI bit.
While ILONG is used to generate the LONGHI status bit,
a transition from TIP-OPEN to the FORWARD-ACTIVE
state (or from the RING-OPEN to the REVERSE-
ACTIVE state) occurs when the RING terminal (or TIP
terminal) is grounded and is based on the LCR bit and
implicitly on exceeding the LCROFFHK threshold.
As an example of ground key detection, suppose that
the Si3220/25 has been programmed with the current
values shown in Table 20.
ILONG, LCR, LONGHI, and CMHIGH is as shown in
Table 21. The entries under “Loop State” indicate the
condition of the loop, as determined by the equipment
terminating the loop. The entries under “LINEFEED
Setting” indicate the state initially selected by the host
CPU (e.g., TIP-OPEN) and the automatic transition to
the FORWARD-ACTIVE state due to a ground key
event (when RING is connected to GND). The transition
from state #2 to state #3 in Table 21 is the automatic
transition from TIP-OPEN to FWD-ACTIVE in response
to LCR = 1.
I
LONG
I
Q1
I
Q6
–
I
Q5
–
I
Q2
+
2
----------------------------------------------------
=
LONGLPF
2
f 4096
800
---------------------------------
2
3
=
Table 20. Settings for Ground Key Example
ILIM
21 mA
LCROFFHK
14 mA
LCRONHK
10 mA
LONGHITH
7 mA
LONGLOTH
5 mA
相關PDF資料 |
PDF描述 |
|---|---|
| SI3216MDCQX-EVB | DAUGHTER CARD W/DISCRETE INTRFC |
| M3TTK-3418J | IDC CABLE - MSD34K/MC34G/MSD34K |
| A3BKB-3418G | IDC CABLE- ASR34B/AE34G/APK34B |
| M3UMK-1036R | IDC CABLE - MKS10K/MC10M/MCG10K |
| M1CXK-3440K | IDC CABLE - MKC34K/MC34F/X |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI3232-X-FQ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DUAL PROGRAMMABLE CMOS SLIC WITH LINE MONITORING |
| SI3232-X-GQ | 制造商:SILABS 制造商全稱:SILABS 功能描述:DUAL PROGRAMMABLE CMOS SLIC WITH LINE MONITORING |
| SI3233 | 制造商:SILABS 制造商全稱:SILABS 功能描述:PROSLIC㈢ PROGRAMMABLE CMOS SLIC WITH RINGING/BATTERY VOLTAGE GENERATION |
| Si3233-C-FM | 功能描述:射頻無線雜項 Single-Chan SLIC RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel |
| SI3233-C-FMR | 功能描述:電信線路管理 IC Single-CH SLIC only BJT/inductor dc-dc RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。