- 您現在的位置：買賣IC網 > PDF目錄9181 > SI5326B-C-GM (Silicon Laboratories Inc)IC ANY-RATE MULTI/ATTEN 36-QFN PDF資料下載
參數資料
| 型號： | SI5326B-C-GM |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 11/72頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ANY-RATE MULTI/ATTEN 36-QFN |
| 標準包裝： | 490 |
| 系列： | DSPLL® |
| 類型： | 時鐘放大器，振動衰減器 |
| PLL： | 是 |
| 輸入： | 時鐘 |
| 輸出： | CML，CMOS，LVDS，LVPECL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:2 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 808MHz |
| 除法器/乘法器： | 是/是 |
| 電源電壓： | 1.71 V ~ 3.63 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 36-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 36-QFN（6x6） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 628 (CN2011-ZH PDF) |
| 其它名稱： | 336-1745 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
Si5326
Rev. 1.0
19
The Si5326 has two differential clock outputs. The
electrical format of each clock output is independently
programmable to support LVPECL, LVDS, CML, or
CMOS loads. If not required, the second clock output
can be powered down to minimize power consumption.
The phase difference between the selected input clock
and the output clocks is adjustable in 200 ps increments
for system skew control using the CLAT[7:0] register.
Fine phase adjustment is available and is set using the
FLAT
register bits. The nominal range and resolution of
the FLAT[14:0] skew adjustment word are: ±110 ps and
3 ps, respectively. In addition, the phase of one output
clock may be adjusted in relation to the phase of the
other output clock. The resolution varies from 800 ps to
2.2 ns depending on the PLL divider settings. See
Table 8 for instructions on ensuring output-to-output
alignment. The input to output skew is not specified.
The DSPLLsim software utility determines the phase
offset
resolution
for
a
given
input
clock/clock
multiplication ratio combination. For system-level
debugging, a bypass mode is available which drives the
output clock directly from the input clock, bypassing the
internal DSPLL. The device is powered by a single 1.8,
2.5, or 3.3 V supply.
4.1. External Reference
An external, high quality clock or a low-cost
114.285 MHz 3rd overtone crystal is used as part of a
fixed-frequency oscillator within the DSPLL. This
external reference is required for the device to perform
jitter attenuation. Silicon Laboratories recommends
using a high quality crystal. Specific recommendations
may be found in the Family Reference Manual.
In digital hold, the DSPLL remains locked and tracks the
external reference. Note that crystals can have
temperature sensitivities.
4.2. Further Documentation
Consult the Silicon Laboratories Si53xx Any Frequency
Precision Clock Family Reference Manual (FRM) for
detailed information about the Si5326 functions.
Additional design support is available from Silicon
Laboratories through your distributor.
Silicon Laboratories has developed a PC-based
software utility called DSPLLsim to simplify device
configuration, including frequency planning and loop
bandwidth selection. The FRM and this utility can be
downloaded from http://www.silabs.com/timing.
Table 8. CKOUT_ALWAYS_ON and SQ_ICAL Truth Table
CKOUT_ALWAYS_ON
SQ_ICAL
Results
0
CKOUT OFF until after the first ICAL
0
1
CKOUT OFF until after the first successful
ICAL (i.e., when LOL is low)
1
0
CKOUT always ON, including during an ICAL
1
CKOUT always ON, including during an ICAL.
Use these settings to preserve output-to-output
skew
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5421CEUB+T | IC VOLTAGE DIVIDER DGLT 10MSOP |
| DS1809Z-100+ | IC DALLASTAT 100K 8-SOIC |
| VI-B7R-MW-B1 | CONVERTER MOD DC/DC 7.5V 100W |
| VE-2W3-MY-F4 | CONVERTER MOD DC/DC 24V 50W |
| MAX5431CEUB+T | IC VOLTAGE DIVIDER PGA 10-UMAX |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI5326B-C-GMR | 功能描述:時鐘合成器/抖動清除器 Precision Clk Xplier Jitter Attn 2In/Out RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| Si5326C-B-GM | 功能描述:鎖相環 - PLL ANY-RATE CLK MULT JITTER ATTEN 2 OUTS RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray |
| Si5326C-C-GM | 功能描述:鎖相環 - PLL ANY-RATE CLK MULT JITTER ATTEN 2 OUTS RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray |
| SI5326C-C-GMR | 功能描述:時鐘合成器/抖動清除器 Precision Clk Xplier Jitter Attn 2In/Out RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| SI5326C-C-GMR-TR | 制造商:Silicon Laboratories Inc 功能描述:SLLSI5326C-C-GMR-TR CLOCK (2 KHZ TO 346 |
發布緊急采購，3分鐘左右您將得到回復。