- 您現在的位置：買賣IC網 > PDF目錄5756 > SMP04ESZ-REEL (Analog Devices Inc)IC AMP SAMPLE HOLD CMOS 16SOIC PDF資料下載
參數資料
| 型號： | SMP04ESZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 15/15頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP SAMPLE HOLD CMOS 16SOIC |
| 標準包裝： | 2,500 |
| 放大器類型： | 采樣和保持 |
| 電路數： | 4 |
| 轉換速率： | 4 V/µs |
| 電流 - 輸入偏壓： | 500nA |
| 電壓 - 輸入偏移： | 2500µV |
| 電流 - 電源： | 4mA |
| 電流 - 輸出 / 通道： | 1.2mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 12 V，±2.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SOIC |
| 包裝： | 帶卷 (TR) |
SMP04
–9–
REV. D
Sample-Mode Distortion Characteristics
Although designed as a sample-and-hold, the SMP04 may be
used as a straight buffer amplifier by configuring it in a continu-
ous sample mode. This is done by connecting the
S/H control
pin to a logic LOW. Its buffer bandwidth is primarily limited by
the distortion content as the signal frequency increases. Figure
17 shows the distortion characteristics of the SMP04 versus
frequency. It maintains less than 1% total harmonic distortion
over a voiceband of 8 kHz. Output spot noise voltage measures
4 nV/
√Hz at f = 1 kHz.
FREQUENCY – Hz
10
20
100k
THD
+
NOISE
–
%
1
100
1k
10k
0.1
0.010
0.001
0.0005
200k
VS = 6V
VIN = 4Vp-p
Figure 17. THD+N vs. Frequency
Sampled Data Dynamic Performance
In continuous sampled data applications such as voice digitiza-
tion or communication circuits, it is important to analyze the
spectral response of a sample-and-hold. Figures 16a and 16b
show the SMP04 sampling at a frequency of 86 kHz with a
1.4 V p-p pure sine wave input of 20 kHz and 8 kHz respec-
tively. The photos include the sampling carrier frequency as
well as its multiplying frequencies. In the case of the 20 kHz
carrier frequency, the second harmonic measures 41 dB down
from the fundamental, because the second is dominant, the
signal-to-noise ratio is –40.9 dB. The 8 kHz case produces an
improved S/N performance of –48 dB.
In the V.32 and V.33 modem environment, where a 1.8 kHz
carrier signal frequency is applied to the SMP04, Figure 18
compares the spectral responses of the SMP04 under three
different sampling frequencies of 14.4 kHz, 9.6 kHz and
7.2 kHz. The signal-to-noise ratios measure 58.2 dB, 59.3 dB
and 60 dB respectively.
Figure 19 depicts SMP04’s spectral response operating with
voice frequency of 3 kHz sampling at a 15.7 kHz rate. Under
this condition, the signal-to-noise measures 53 dB.
10 dB/DIV
RANGE 15.0 dBm
5.9 dBm
START 1 000.0 Hz
STOP 20 000.0 Hz
Figure 19. SMP04 Spectral Response with an Input Carrier
Frequency of 3 kHz and the Sampling Frequency of 15.7 kHz
Sampled Data Dynamic Performance
In continuous sampled data applications such as voice digitiza-
tion or communication circuits, it is important to analyze the
spectral response of a sample-and-hold. Figures 16a and 16b
show the SMP04 sampling at a frequency of 86 kHz with a
1.4 V p-p pure sine wave input of 20 kHz and 8 kHz respec-
tively. The photos include the sampling carrier frequency as well
as its multiplying frequencies. In the case of the 20 kHz carrier
frequency, the second harmonic measures 41 dB down from the
fundamental, because the second is dominant, the signal-to-
noise ratio is –40.9 dB. The 8 kHz case produces an improved
S/N performance of –48 dB.
In the V.32 and V.33 modem environment, where a 1.8 kHz
carrier signal frequency is applied to the SMP04, Figure 18
compares the spectral responses of the SMP04 under three
different sampling frequencies of 14.4 kHz, 9.6 kHz and
7.2 kHz. The signal-to-noise ratios measure 58.2 dB, 59.3 dB
and 60 dB respectively.
Figure 18. SMP04 Spectral Response with a 1.8 kHz Carrier Frequency. (a) Shows the Sampling Frequency at 14.4 kHz;
it Exhibits a S/N Ratio of 58.2 dB. (b) Shows a 59.3 dB S/N at a Sampling Frequency of 8.6 kHz. (c) Shows a 60 dB S/N at
7.2 kHz.
10 dB/DIV
RANGE 15.0 dBm
5.9 dBm
CENTER 10 500.0 Hz
SPAN 19 000.0 Hz
a.
10 dB/DIV
RANGE 15.0 dBm
5.2 dBm
START 1 000.0 Hz
STOP 12 000.0 Hz
c.
10 dB/DIV
RANGE 15.0 dBm
5.7 dBm
START 1 000.0 Hz
STOP 12 000.0 Hz
b.
相關PDF資料 |
PDF描述 |
|---|---|
| 55867-1 | CONN SPADE TONGUE 22-18AWG #8 |
| 104742-2 | CONN BUSBAR CLIP |
| LRC-LR2512LF-01-1R00-F | RES 1 OHM 2W 1% 2512 SMD |
| 69192-140HLF | BERGSTIK II DR STRAIGHT RET |
| 1-1470224-5 | CONN HEADER 15POS VERT HPI T/H |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SMP04GBC | 制造商:AD 制造商全稱:Analog Devices 功能描述:CMOS Quad Sample-and-Hold Amplifier |
| SMP-04V-BC | 制造商:JST Manufacturing 功能描述:4 1 Housing vO 10.5mm 250VDC / 250VAC 3A 85 -25 22-28AWG 11.7mm 7.4mm 制造商:JST Manufacturing 功能描述:4 Position 2.5 mm Pitch Disconnectable Housing Plug 制造商:JST 功能描述:Connector 制造商:JST Manufacturing 功能描述:Connector,Plastic Hsng Lance,Multipole |
| SMP-04V-NC | 制造商:JST Manufacturing 功能描述:Conn Housing PL 4 POS Crimp ST Bag 制造商:JST Manufacturing 功能描述:CONNECTOR HOUSING PLUG 4 WAY PLASTIC 制造商:JST Manufacturing 功能描述:CONNECTOR HOUSING, PLUG, 4 WAY, PLASTIC 制造商:JST Manufacturing 功能描述:2.5mm Wire to Wire connector, Natural colour Plug Housing 制造商:JST Manufacturing 功能描述:Connector 制造商:JST Manufacturing 功能描述:CONNECTOR, HOUSING, PLUG, 4POS, 1ROW, Product Range:JST - SM Series, Contact Termination:-, Gender:Plug, No. of Contacts:4, No. of Rows:1, Pitch Spacing:2.5mm, Contact Plating:-, Contact Material:-, Connector Type:Wire to Board , RoHS Compliant: Yes 制造商:JST Manufacturing 功能描述:CONNECTOR HOUSING, PLUG, 4 WAY, PLASTIC, Series:SM, No. of Positions:4, Pitch Sp |
| SMP-05V-BC | 制造商:JST Manufacturing 功能描述:5 1 Housing vO 13mm 250VDC / 250VAC 3A 85 -25 22-28AWG 11.7mm 7.4mm 制造商:JST Manufacturing 功能描述:5 Position 2.5 mm Spacing Plug Housing 制造商:JST 功能描述:Connector 制造商:JST Manufacturing 功能描述:Connector,Plastic Housing Lance,Multipo |
| SMP-05V-NC | 制造商:JST Manufacturing 功能描述:5 1 Housing 85 -25 13mm 250VDC / 250VAC 3A 85 -25 22-28AWG 13mm 11.7mm 7.4mm 11.7mm |
發布緊急采購，3分鐘左右您將得到回復。