- 您現在的位置：買賣IC網 > PDF目錄372180 > SP334ET 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors PDF資料下載
參數資料
| 型號： | SP334ET |
| 元件分類： | RS-232 |
| 英文描述： | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| 中文描述： | 5V的高速RS - 232收發器與0.1uF電容 |
| 文件頁數： | 9/12頁 |
| 文件大小： | 155K |
| 代理商： | SP334ET |
9
SP334DS/10
Programmable RS-232/RS-485 Transceiver
Copyright 2000 Sipex Corporation
Figure 15. Charge Pump Phase 3.
Figure 16. Charge Pump Phase 4.
operation the relative position and functionality
of the drivers are set up to accommodate the
selected interface mode. As the mode of the
drivers is changed, the electrical characteristics
will change to support the requirements of clock,
data, and control line signal levels. Unused
driver inputs can be left floating; however, to
ensure a desired state with no input signal,
pull–up resistors to +5V or pull–down resistors
to ground are suggested. Since the driver inputs
are both TTL or CMOS compatible, any value
resistor less than 100k
will suffice.
When in RS-232 mode, the single-ended RS-
232 drivers produce compliant RS-232E and
ITU V.28 signals. Each of the three drivers
output single-ended bipolar signals in excess of
V
CC
= +5V
–5V
+5V
–5V
V
SS
Storage Capacitor
V
DD
Storage Capacitor
C
1
C
2
C
3
C
4
+
+
+
+
–
–
–
–
V
CC
= +5V
+10V
V
SS
Storage Capacitor
V
DD
Storage Capacitor
C
1
C
2
C
3
C
4
+
+
+
+
–
–
–
–
Figure 17. Charge Pump Waveforms
±
5V with a full load of 3k
and 2500pF applied
as specified. These drivers can also operate at
least 120kbps.
When programmed to RS-485 mode, the
differential RS-485 drivers produce complaint
RS-485 signals. Each RS-485 driver outputs
a unipolar signal on each output pin with a
magnitude of at least 1.5V while loaded with
a worst case of 54
between the driver's two
output pins. The signal levels and drive
capability of the RS-485 drivers allow the
drivers to also comply with RS-422 levels. The
transmission rate for the differential drivers is
10Mbps.
Receivers
The
SP334
has five single-ended receivers
when programmed for RS-232 mode and two
differential receivers when programmed for
RS-485 mode.
Control for the mode selection is done by the
same select pin as the drivers. As the operating
mode of the receivers is changed, the electrical
characteristics will change to support the
requirements of the appropriate serial standard.
Unused receiver inputs can be left floating
without causing oscillation. To ensure a desired
state of the receiver output, a pull–up resistor of
100k
to +5V should be connected to the
inverting input for a logic low, or the
non–inverting input for a logic high. For
single-ended receivers, a pull–down resistor to
ground of 5k
is internally connected, which
will ensure a logic high output.
+10V
a) C
2
+
GND
GND
-10V
b) C
2
-
相關PDF資料 |
PDF描述 |
|---|---|
| SP3481 | Cermet Potentiometer; Resistance Max:10kohm; Resistance Tolerance:+/- 10 %; Power Rating:1W; Voltage Rating:350V; Series:149; Temperature Coefficient:+/-150 ppm; Resistor Element Material:Cermet; Leaded Process Compatible:Yes |
| SP3481CN | +3.3V Low Power Half-Duplex RS-485 Transceivers with 10Mbps Data Rate |
| SP3481CP | +3.3V Low Power Half-Duplex RS-485 Transceivers with 10Mbps Data Rate |
| SP3481EN | +3.3V Low Power Half-Duplex RS-485 Transceivers with 10Mbps Data Rate |
| SP3481EP | +3.3V Low Power Half-Duplex RS-485 Transceivers with 10Mbps Data Rate |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP334ET-L | 功能描述:RS-232接口集成電路 RS232/422/RS485 Transceiver Multi RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| SP334ET-L/TR | 功能描述:RS-232接口集成電路 Programmable RS232/ RS485 Transceiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| SP3-3-50 | 制造商:RHOMBUS-IND 制造商全稱:Rhombus Industries Inc. 功能描述:SP3 Series Mini-SIP Passive Delay Modules |
| SP3-3501 | 功能描述:CONN 3.5MM MALE STEREO PWR PLUG RoHS:是 類別:連接器，互連式 >> 套管 - 音頻 系列:- 標準包裝:1 系列:SealTite® 連接器類型:唱機（RCA）插座 類型:公頭 信號線路:單聲道 插頭/配接插頭直徑:3.20mm 內徑，9.00mm 外徑（RCA） 位置/觸點數:2 導線，2 觸點 內部開關:不包括開關 安裝類型:自由懸掛 端子:壓縮 屏蔽:無屏蔽 特點:- 色彩 - 觸頭:金 觸點材料:- 觸點材料 - 鍍層:- 體座材料:- 體座顏色:銀 工作溫度:- 電壓 - 額定:- 額定電流:- 包裝:散裝 |
| SP3-3-55 | 制造商:RHOMBUS-IND 制造商全稱:Rhombus Industries Inc. 功能描述:SP3 Series Mini-SIP Passive Delay Modules |
發布緊急采購，3分鐘左右您將得到回復。