參數資料
型號： ST7LITE09Y0B6
英文描述： FUSE, FORK LIFT TRUCK, 200A; Current, fuse rating:200A; Voltage rating, DC:80V; Approval category:DIN 43560/1; Depth, external:20mm; Height:1mm; Length / Height, external:0.5mm; Width, external:82mm RoHS Compliant: Yes
中文描述： ST7LITE0。 ST7SUPERLITE - 8位微控制器單電壓閃存。數據EEPROM。 ADC的。定時器。的SPI
文件頁數： 69/122頁
文件大小： 1716K
代理商： ST7LITE09Y0B6
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁當前第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁
ST7LITE0, ST7SUPERLITE
69/122
8-BIT A/D CONVERTER (ADC)
(Cont’d)
11.4.3.3 Digital A/D Conversion Result
The conversion is monotonic, meaning that the re-
sult never decreases if the analog input does not
and never increases if the analog input does not.
If the input voltage (V
AIN
) is greater than or equal
to V
DDA
(high-level voltage reference) then the
conversion result in the DR register is FFh (full
scale) without overflow indication.
If input voltage (V
AIN
) is lower than or equal to
V
SSA
(low-level voltage reference) then the con-
version result in the DR register is 00h.
The A/D converter is linear and the digital result of
the conversion is stored in the ADCDR register.
The accuracy of the conversion is described in the
parametric section.
R
AIN
is the maximum recommended impedance
for an analog input signal. If the impedance is too
high, this will result in a loss of accuracy due to
leakage and sampling not being completed in the
alloted time.
11.4.3.4 A/D Conversion Phases
The A/D conversion is based on two conversion
phases as shown in
Figure 44
:
I
Sample capacitor loading [duration: t
SAMPLE
]
During this phase, the V
AIN
input voltage to be
measured is loaded into the C
ADC
sample
capacitor.
I
A/D conversion [duration: t
HOLD
]
During this phase, the A/D conversion is
computed (8 successive approximations cycles)
and the C
ADC
sample capacitor is disconnected
from the analog input pin to get the optimum
analog to digital conversion accuracy.
I
The total conversion time:
t
CONV =
t
SAMPLE
+ t
HOLD
While the ADC is on, these two phases are contin-
uously repeated.
At the end of each conversion, the sample capaci-
tor is kept loaded with the previous measurement
load. The advantage of this behaviour is that it
minimizes the current consumption on the analog
pin in case of single input channel measurement.
11.4.3.5 Software Procedure
Refer to the control/status register (CSR) and data
register (DR) in
Section 11.4.6
for the bit defini-
tions and to
Figure 44
for the timings.
ADC Configuration
The analog input ports must be configured as in-
put, no pull-up, no interrupt. Refer to the I/O
ports chapter. Using these pins as analog inputs
does not affect the ability of the port to be read as
a logic input.
In the CSR register:
– Select the CH[2:0] bits to assign the analog
channel to be converted.
ADC Conversion
In the CSR register:
– Set the ADON bit to enable the A/D converter
and to start the first conversion. From this time
on, the ADC performs a continuous conver-
sion of the selected channel.
When a conversion is complete
– The EOC bit is set by hardware.
– No interrupt is generated.
– The result is in the DR register and remains
valid until the next conversion has ended.
A write to the ADCCSR register (with ADON set)
aborts the current conversion, resets the EOC bit
and starts a new conversion.
Figure 44. ADC Conversion Timings
11.4.4 Low Power Modes
Note
: The A/D converter may be disabled by reset-
ting the ADON bit. This feature allows reduced
power consumption when no conversion is needed
and between single shot conversions.
11.4.5 Interrupts
None
Mode
Description
WAIT
No effect on A/D Converter
A/D Converter disabled.
After wakeup from Halt mode, the A/D Con-
verter requires a stabilization time before ac-
curate conversions can be performed.
HALT
ADCCSR WRITE
OPERATION
ADON
EOC BIT SET
t
SAMPLE
t
HOLD
HOLD
CONTROL
t
CONV
1
相關PDF資料
PDF描述
ST7LITE09Y0M6 FUSE, FORK LIFT TRUCK, 250A; Current, fuse rating:250A; Voltage rating, DC:80V; Approval category:DIN 43560/1; Depth, external:20mm; Height:1mm; Length / Height, external:0.5mm; Width, external:82mm RoHS Compliant: Yes
ST7LITE10F1B6 ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI
ST7LITE10F1M6 FUSE PULLER/TESTERFUSE PULLER/TESTER; Depth, external:15mm; Length:60mm; Voltage rating, AC:24V; Voltage rating, DC:24V; Width, external:20mm
ST7LITE15F1B6 CLIP FUSE 10A 5X20MM PC MOUNT
ST7LITE15F1M6 CLIP FUSE 15A VERT ATO PC MOUNT
相關代理商/技術參數
參數描述
ST7LITE09Y0M6 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ST7LITE0. ST7SUPERLITE - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY. DATA EEPROM. ADC. TIMERS. SPI
ST7LITE0X 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MICROCONTROLLER WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI
ST7LITE0XY0 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-bit microcontroller with single voltage Flash memory, data EEPROM, ADC, timers, SPI
ST7LITE1 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 4 TIMERS, SPI
ST7LITE10F1B6 制造商:未知廠家 制造商全稱:未知廠家 功能描述:ST7LITE1 - 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY.DATA EEPROM. ADC. 4 TIMERS. SPI
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*