- 您現在的位置：買賣IC網 > PDF目錄9662 > SY87700ALHG TR (Micrel Inc)IC CLOCK/DATA RECOVERY 32-TQFP PDF資料下載
參數資料
| 型號： | SY87700ALHG TR |
| 廠商： | Micrel Inc |
| 文件頁數： | 6/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CLOCK/DATA RECOVERY 32-TQFP |
| 標準包裝： | 1,000 |
| 系列： | AnyRate® |
| 類型： | 時鐘和數據恢復（CDR），多路復用器 |
| PLL： | 是 |
| 主要目的： | 以太網，SONET/SDH，ATM 應用 |
| 輸入： | PECL |
| 輸出： | PECL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:3 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 208Mbps |
| 電源電壓： | 3.15 V ~ 3.45 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-TQFP 裸露焊盤 |
| 供應商設備封裝： | 32-EPAD-TQFP |
| 包裝： | 帶卷 (TR) |
| 其它名稱： | SY87700ALHGTR SY87700ALHGTR-ND |
MCP7940N
DS25010C-page 14
2011 Microchip Technology Inc.
With bits RS1 and RS0 set to ‘00’, the calibration
function can be expressed as:
Since the calibration is done once per minute (i.e.,
when the internal minute counter is incremented), only
one cycle in sixty of the MFP output waveform is
affected by the calibration setting. Also note that the
duty cycle of the MFP output waveform will not
necessarily be at 50% when the calibration setting is
applied.
With bits RS1 and RS0 set to ‘01’ or ‘10’, the
calibration function can not be expressed in terms of
the input clock period. In the case where the MSB of
the Calibration register is set to ‘0’, the waveform
appearing at the MFP output pin will be “delayed”,
once per minute, by twice the number of input clock
cycles defined in the Calibration register. The MFP
waveform will appear as:
FIGURE 5-2:
RS1 AND RS0 WITH AND WITHOUT CALIBRATION
In the case where the MSB of the Calibration register
is set to ‘1’, the MFP output waveforms that appear
when bits RS1 and RS0 are set to ‘01’ or ‘10’ are not
as responsive to the setting of the Calibration register.
For example, when outputting the 4.096 kHz
waveform (RS1, RS0 set to ‘01’), the output waveform
is generated using only eight input clock cycles.
Consequently, attempting to subtract more than eight
input clock cycles from this output does not have a
meaningful effect on the resulting waveform. Any
effect on the output will appear as a modification in
both the frequency and duty cycle of the waveform
appearing on the MFP output pin.
B.RS2 BIT SET TO ‘1’
With the RS2 bit set to ‘1’, the following internal timing
signal is output on the MFP pin:
The frequency listed in the table presumes an input
clock source of exactly 32.768 kHz. In terms of the
equivalent number of input clock cycles, the table
becomes:
Unlike
the
method
previously
described,
the
calibration setting is continuously applied and affects
every cycle of the output waveform. This results in the
modulation of the frequency of the output waveform
based upon the setting of the Calibration register.
Using this setting, the calibration function can be
expressed as:
Since the calibration is done every cycle, the frequency
of the output MFP waveform is constant.
Toutput
=
(32768 +/- (2 * CALREG)) Tinput
where:
Toutput
=
clock period of MFP output signal
Tinput
=
clock period of input signal
CALREG
=
decimal value of Calibration
register setting and the sign is
determined by the MSB of
Calibration register.
Delay
RS2
RS1
RS0
Output Signal
1
x
64.0 Hz
RS2
RS1
RS0
Output Signal
1
x
512
Toutput = (2 * (256 +/- (2 * CALREG))) Tinput
where:
Toutput = clock period of MFP output signal
Tinput = clock period of input signal
CALREG
=
decimal value of the Calibration
register setting, and the sign is
determined by the MSB of the
Calibration register.
相關PDF資料 |
PDF描述 |
|---|---|
| MS27467E25A2PD | CONN PLUG 100POS STRAIGHT W/PINS |
| SY69952ZH TR | IC TXRX CLOCK RECOVERY 28-SOIC |
| VE-BWV-MW-F1 | CONVERTER MOD DC/DC 5.8V 100W |
| VE-BW0-MW-F4 | CONVERTER MOD DC/DC 5V 100W |
| MS27467E25A2PB | CONN PLUG 100POS STRAIGHT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SY87700ALZG | 功能描述:計時器和支持產品 3.3V 32Mbps-175Mbps CDR (I Temp, Green/28 pin SOIC/bulk) RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| SY87700ALZG TR | 功能描述:計時器和支持產品 3.3V 32Mbps-175Mbps CDR (I Temp, Green/28 pin SOIC/T+R) RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| SY87700L | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V 32-175Mbps AnyRate CLOCK AND DATA RECOVERY |
| SY87700L_06 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V 32-175Mbps AnyRate CLOCK AND DATA RECOVERY |
| SY87700LHG | 功能描述:計時器和支持產品 3.3V 32Mbps-175Mbps CDR (I Temp, Green/32 pin TQFP/bulk) RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。