- 您現在的位置：買賣IC網 > PDF目錄371181 > TDA3608 (NXP Semiconductors N.V.) Multiple voltage regulator with switch PDF資料下載
參數資料
| 型號： | TDA3608 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Multiple voltage regulator with switch |
| 中文描述： | 多帶開關穩壓器 |
| 文件頁數： | 2/20頁 |
| 文件大小： | 123K |
| 代理商： | TDA3608 |
1997 Aug 14
2
Philips Semiconductors
Preliminary specification
Multiple voltage regulator with switch
TDA3608Q
FEATURES
General
Two V
P
-state controlled regulators (regulator 1 and 3)
and a power switch
Regulator 2 and reset operate during load dump and
thermal shutdown
Separate control pins for switching regulator 1,
regulator 3 and the power switch
Supply voltage range of
18 to +50 V
Low reverse current of regulator 2
Low quiescent current (when regulator 1, regulator 3,
and power switch are switched off)
Hold output (only valid when regulator 1 is switched on)
Reset and hold outputs (open collector outputs)
Adjustable reset delay time
High ripple rejection
Back-up capacitor for regulator 2.
Protections
Reverse polarity safe (down to
18 V without high
reverse current)
Able to withstand voltages up to 18 V at the outputs
(supply line may be short-circuited)
ESD protected on all pins
Thermal protection
Load dump protection
Foldback current limit protection
for regulators 1, 2 and 3
Delayed second current limit protection for the power
switch (at short-circuit)
The regulator outputs and the power switch are
DC short-circuited safe to ground and V
P
.
GENERAL DESCRIPTION
The TDA3608Q is a multiple output voltage regulator with
a power switch, intended for use in car radios with or
without a microcontroller. It contains:
Two fixed voltage regulators with a foldback current
protection (regulator 1 and regulator 3) and one fixed
voltage regulator (regulator 2), intended to supply a
microcontroller, that also operates during load dump
and thermal shutdown.
A power switch with protections, operated by an enable
input
Reset and hold outputs that can be used to interface by
the microcontroller. The reset signal can be used to call
up the microcontroller and the hold output indicates
regulator 1 voltage available and within range.
A supply pin which can withstand load dump pulses and
negative supply voltages
Regulator 2 that will be switched on at a back-up voltage
higher than 6.5 V and off when the output voltage of
regulator 2 drops below 1.9 V
A provision for use of a reserve supply capacitor that will
hold enough energy for regulator 2 (5 V continuous) to
allow a microcontroller to prepare for loss of voltage.
ORDERING INFORMATION
TYPE NUMBER
PACKAGE
NAME
DESCRIPTION
VERSION
TDA3608Q
DBS13P
plastic DIL-bent-SIL power package; 13 leads (lead length 12 mm)
SOT141-6
相關PDF資料 |
PDF描述 |
|---|---|
| TDA3609 | Multiple voltage regulator with switch and ignition buffers |
| TDA3609JR | Multiple voltage regulator with switch and ignition buffers |
| TDA3651 | VERTICAL DEFLECTION CIRCUIT |
| TDA3651A | VERTICAL DEFLECTION CIRCUIT |
| TDA3651Q | VERTICAL DEFLECTION CIRCUIT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA3608Q | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multiple voltage regulator with switch |
| TDA3608Q/N3C | 功能描述:低壓差穩壓器 - LDO CARRADIO POWER AMPS RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TDA3608Q/N3C,112 | 功能描述:低壓差穩壓器 - LDO CARRADIO POWER AMPS RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TDA3608TH | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multiple voltage regulators with switch |
| TDA3608TH/N3C | 功能描述:低壓差穩壓器 - LDO CARRADIO POWER AMPS RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。