- 您現在的位置：買賣IC網 > PDF目錄371181 > TDA4780 (NXP SEMICONDUCTORS) RGB video processor with automatic cut-off control and gamma adjust PDF資料下載
參數資料
| 型號： | TDA4780 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 消費家電 |
| 英文描述： | RGB video processor with automatic cut-off control and gamma adjust |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PDIP28 |
| 封裝： | 0.600 INCH, PLASTIC, DIP-28 |
| 文件頁數： | 42/44頁 |
| 文件大?。?/td> | 321K |
| 代理商： | TDA4780 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁當前第42頁第43頁第44頁
1997 Feb 06
42
Philips Semiconductors
Preliminary specification
RGB video processor with automatic
cut-off control and gamma adjust
TDA4780
SOLDERING
Introduction
There is no soldering method that is ideal for all IC
packages. Wave soldering is often preferred when
through-hole and surface mounted components are mixed
on one printed-circuit board. However, wave soldering is
not always suitable for surface mounted ICs, or for
printed-circuits with high population densities. In these
situations reflow soldering is often used.
This text gives a very brief insight to a complex technology.
A more in-depth account of soldering ICs can be found in
our “IC Package Databook”(order code 9398 652 90011).
Soldering by dipping or by wave
The maximum permissible temperature of the solder is
260
°
C; solder at this temperature must not be in contact
with the joint for more than 5 seconds. The total contact
time of successive solder waves must not exceed
5 seconds.
The device may be mounted up to the seating plane, but
the temperature of the plastic body must not exceed the
specified maximum storage temperature (T
stg max
). If the
printed-circuit board has been pre-heated, forced cooling
may be necessary immediately after soldering to keep the
temperature within the permissible limit.
Repairing soldered joints
Apply a low voltage soldering iron (less than 24 V) to the
lead(s) of the package, below the seating plane or not
more than 2 mm above it. If the temperature of the
soldering iron bit is less than 300
°
C it may remain in
contact for up to 10 seconds. If the bit temperature is
between 300 and 400
°
C, contact may be up to 5 seconds.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA4864AJ | Vertical deflection booster |
| TDA4864J | Vertical deflection booster |
| TDA4867J | Full bridge current driven vertical deflection booster |
| TDA4867 | Full bridge current driven vertical deflection booster |
| TDA6107JF | Triple video output amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA4800 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Vertical deflection circuit for monitor applications |
| TDA4810 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:SYNC PROCESSOR AND HORIZONTAL DRIVE FOR MONITORS |
| TDA4814 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Power Factor Controller IC for High Power Factor and Active Harmonic Filter |
| TDA4814A | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Power Factor Controller IC for High Power Factor and Active Harmonic Filter |
| TDA4817 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Power Factor Controller IC for High Power Factor and Active Harmonic Filtering |
發布緊急采購，3分鐘左右您將得到回復。