- 您現在的位置：買賣IC網 > PDF目錄368629 > TDA5153 (NXP Semiconductors N.V.) Pre-amplifier for Hard Disk Drive HDD with MR-read/inductive write heads PDF資料下載
參數資料
| 型號： | TDA5153 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | Pre-amplifier for Hard Disk Drive HDD with MR-read/inductive write heads |
| 中文描述： | 預硬盤驅動器硬盤驅動器放大器MR-read/inductive寫磁頭 |
| 文件頁數： | 22/28頁 |
| 文件大小： | 128K |
| 代理商： | TDA5153 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁
1997 Jul 02
22
Philips Semiconductors
Preliminary specification
Pre-amplifier for Hard Disk Drive (HDD)
with MR-read/inductive write heads
TDA5153
5.
The PSRR (in dB) is defined as input referred ratio:
G
v
G
p
Where G
v
is the differential input to differential output
gain, and G
p
is the power supply to differential output
gain. The CMRR (in dB) is defined as input referred
×
=
ratio:
where G
v
is the differential input to differential output
gain and G
cm
is the common mode input to differential
output gain. Flex and board lay-out may affect
significantly these parameters.
This refers to the crosstalk from SCLK and SDATA
inputs via the read inputs to RDx
RDy. Two cases
can be distinguished:
a) With SEN LOW, SCLK and SDATA are prohibited
from entering the device and crosstalk is low.
b) Programming via the serial interface is done with
SEN HIGH. Then crosstalk can occur. A careful
design of the board or flex-foil is required in order
not to get crosstalk via this path.
A 200 mV peak-to-peak signal is applied to SCLK or
SDATA inputs at 25 MHz, and measurement is
performed at RDx
RDy.
6.
7.
PSRR
20
log
------
×
=
CMRR
20
log
G
v
G
cm
----------
8.
The rise and fall times depend on the write
amplifier-write head combination. L
h
and R
h
represent
the components on the evaluation board. Parasitic
capacitances also limit the performance.
9.
The write current rise/fall time asymmetry is defined by
t
t
–
2 t
r
t
f
+
10. Write-to-read recovery time includes the write mode to
read mode switching using the R/W pin on the same
head (see Fig.6). The AC signal reaches its full
amplitude few tenth of ns after appearing at the reader
RDx and RDy outputs.
11. In read mode, the head switching, standby to read
active switching and changing MR current include fast
current settling (see Fig.7). Same note regarding the
AC signals at the reader outputs as above.
12. Write settle time includes read mode to write mode
switching using the R/W pin.
13. The typical supply current in read mode depends on
the bias current for the MR element.
14. The typical supply current in write mode also depends
on the write current.
(
)
-----------------------
Table 1
Noise figure
R
MR
(
)
F (dB)
I
MR
= 7 mA
2.7
2.8
2.9
I
MR
= 10 mA
2.9
3.0
3.1
I
MR
= 15 mA
3.1
3.3
3.5
20
25
30
相關PDF資料 |
PDF描述 |
|---|---|
| TDA5153X | Pre-amplifier for Hard Disk Drive HDD with MR-read/inductive write heads |
| TDA5153BG | Pre-amplifier for Hard Disk Drive HDD with MR-read/inductive write heads |
| TDA5634T | 9 V UHF mixer/oscillator for TV and VCR tuners |
| TDA5731M | Low power VHF, UHF andhyperband mixer/oscillator for TVand VCR 3-band tuners(應用于TV和 VCR三頻帶調諧的低功耗VHF，UHF和超頻帶混頻器/振蕩器) |
| TDA5732 | Low power VHF, UHF mixer/oscillator for TV and VCR 2-band tuners |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA5153AG | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pre-amplifier for Hard Disk Drive HDD with MR-read/inductive write heads |
| TDA5153BG | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pre-amplifier for Hard Disk Drive HDD with MR-read/inductive write heads |
| TDA5153X | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pre-amplifier for Hard Disk Drive HDD with MR-read/inductive write heads |
| TDA5155 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pre-amplifier for Hard Disk Drive HDD with MR-read/inductive write heads |
| TDA5155X | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Pre-amplifier for Hard Disk Drive HDD with MR-read/inductive write heads |
發布緊急采購，3分鐘左右您將得到回復。