- 您現在的位置：買賣IC網 > PDF目錄373622 > TDA7403D (意法半導體) BASIC SIGNAL PROCESSOR PDF資料下載
參數資料
| 型號： | TDA7403D |
| 廠商： | 意法半導體 |
| 英文描述： | BASIC SIGNAL PROCESSOR |
| 中文描述： | 基本信號處理器 |
| 文件頁數： | 8/26頁 |
| 文件大?。?/td> | 195K |
| 代理商： | TDA7403D |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
Softmute
The digitally controlled softmute stage allows
muting/demuting the signal with a I
2
C bus pro-
grammable slope. The mute process can either
be activated by the softmute pin or by the I
2
C
bus. The slope is realized in a special S shaped
curve to mute slow in the critical regions (see fig-
ure 5).
For timing purposes the Bit 3 of the I
2
C bus out-
put register is set to 1 from the start of muting un-
til the end of demuting.
Softstep Volume
When volume level is changed often an audible
click appears at the output. The root cause of
those clicks could be either a DC offset before
the volume stage or the sudden change of the
envelope of the audio signal. With the Softstep
feature both kinds of clickscould be reduced to a
minimum and are no more audible(see figure 6).
Bass
There are three parameters programmable in the
bass stage(see figs 7, 8, 9, 10):
- Attenuation
- Center Frequency (60, 70, 80 and 100Hz)
- QualityFactors(1, 1.25, 1.5 and 2)
DC Mode
In this mode the DC gain is increased by 4.4dB.
In addition the programmedcenter frequencyand
quality factor is decreased by 25% which can be
used to reach alternative center frequencies or
quality factors.
Treble
There are two parameters programmable in the
treble stage (see figs 11, 12):
- Attenuation
- Center Frequency(10, 12.5, 15 and 17.5kHz).
Speaker Attenuator
Due to practical aspects the steps in the speaker
attenuators are not linear over the full range. At
attenuations more than 24dB the steps increase
from 1.5dB to 10dB (please see data byte specifi-
cation).
10
100
1,000
Hz
-20
-15
-10
-5
(dB)
D98AU844
Figure 4. Loudness @ Attn.= 15dB,fc = 400Hz
1
EXT.
MUTE
+SIGNAL
REF
-SIGNAL
1
I
2
C
BUS
OUT
Time
D97AU634
Figure 5. Softmute Timing
2dB
1dB
-1dB
-2dB
Time
D97AU635
VOUT
10ms
Figure 6. SoftStep Timing
Note: Please notice that a startedMute action is always terminated
and could not be interrupted by a change of the mute signal.
Note: For steps more than 1dB the softstep mode should be
deactivated because it could generate a 1dB error during the
blend-time
TDA7403
8/26
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7404 | CARRADIO-SIGNAL-PROCESSOR |
| TDA7404D | CARRADIO-SIGNAL-PROCESSOR |
| TDA7405 | EQUALIZER CARRADIO SIGNAL PROCESSOR |
| TDA7406T | CAR RADIO SIGNAL PROCESSOR |
| TDA7406 | Car radio signal processor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7403DTR | 功能描述:音頻 DSP Basic Signal Process RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7404 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:CARRADIO-SIGNAL-PROCESSOR |
| TDA7404_08 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Car radio signal processor |
| TDA7404D | 功能描述:音頻 DSP Car Radio Signal RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7404DTR | 功能描述:音頻 DSP Car Radio Signal RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。