- 您現在的位置：買賣IC網 > PDF目錄385925 > THS14F03EVM (Texas Instruments, Inc.) THS14F03EVM(THS14F03評估板) PDF資料下載
參數資料
| 型號： | THS14F03EVM |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | THS14F03EVM(THS14F03評估板) |
| 中文描述： | THS14F03EVM（THS14F03評估板） |
| 文件頁數： | 19/39頁 |
| 文件大?。?/td> | 523K |
| 代理商： | THS14F03EVM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁
Circuit Function
3-2
3.1
Circuit Function
The following paragraphs describe the function of the individual circuits. Refer
to the relevant data sheet for device operating characteristics.
3.1.1
Inputs and Outputs
The ADC has differential analog inputs. These are provided via SMB connec-
tors J10 and J11 on the EVM, and can be configured in two ways:
For true differential input, the positive differential signal is connected to
J10 and the negative differential signal is connected to J11. The jumpers
on the board are then configured as: H7 (1–2), H8 (2–3), and H9 (1–2).
The inputs have 50-
terminators.
For single-ended input, a positive signal is applied to connector J10. The
jumpers on the board are then configured as: H7 (2–3), H8 (1–2), and H9
(2–3). Transformer T2 performs the single-ended to differential signal con-
version. In this mode, the 50-
terminators R27 and R28 perform imped-
ance matching to attain the best distortion performance, but the signal
source must be able to drive the 25-
load. A 50-
source can be used
if R27 is removed from the board, with a resulting marginal increase in dis-
tortion.
SMB connector J3 can be used to input a clock signal to the board from an ex-
ternal source. If the source is not at the correct dc level required to input to the
74AHC14 hex inverter IC (U7), then it can be ac-coupled through C21, with the
dc level trimmed using potentiometer P1 if necessary.
The EVM is designed to comply with the TI TMS320C6000 daughtercard
specification. The pinout used is listed in Tables 3–1 and 3–2. In order to make
the EVM compatible with both the TMS320C6XXX and TMS320C5XXX
motherboard design environments, the EVM chip enable is derived from the
following sources:
OUT_CE (J1 P78) for the TMS320C6XXX, by inserting a jumper link in
position 2–3 of H15.
OUT_IS (J2 P70) for the TMS320C5XXX, by inserting a jumper link in
position 1–2 of H15.
For further explanation of the daughtercard connector interface, refer to the
relevant motherboard user’s guide or daughtercard specification.
Buffers U1, U2, and U3 are used to avoid bus contention and provide a degree
of noise isolation from the DSP motherboard.
相關PDF資料 |
PDF描述 |
|---|---|
| THS1408EVM | THS1408EVM(THS1408評估板) |
| THS3110EVM | THS3110 Evalutation Module(THS3110評估板) |
| THS3202EVM | THS3202 Evalutation Module(THS3202評估板) |
| THS4120EVM | THS4120 Evalutation Module(THS4120評估板) |
| THS4121EVM | THS4121 Evalutation Module(THS4121評估板) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS14F03IPFB | 功能描述:模數轉換器 - ADC 14-bit 3 MSPS with 32-word FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| THS14F03IPFBG4 | 功能描述:模數轉換器 - ADC 14-bit 3 MSPS with 32-word FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| THS14-THS18-D | 制造商:Thomas & Betts 功能描述:CATAMOUNT CABLE TIES |
| THS15 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:EURO TERMINAL BLOCKS |
| THS15100RJ | 功能描述:線繞電阻器 - 底架安裝 THS15 100R 5% RoHS:否 制造商:Vishay/Dale 電阻:7 Ohms 容差:1 % 功率額定值:100 W 溫度系數:50 PPM / C 系列:RH 工作溫度范圍:- 55 C to + 250 C 尺寸:46.02 mm Dia. x 46.02 mm W x 88.9 mm L x 44.45 mm H 封裝:Bulk 產品:Power Resistors Wirewound Aluminum Housed |
發布緊急采購，3分鐘左右您將得到回復。