參數資料
型號： THS6182DR
廠商： Texas Instruments, Inc.
英文描述： LOW-POWER DISSIPATION ADSL LINE DRIVER
中文描述： 低功耗ADSL線路驅動器
文件頁數： 17/35頁
文件大?。?/td> 1242K
代理商： THS6182DR
www.ti.com
RECOMMENDED FEEDBACK AND GAIN RESISTOR VALUES
As with all current feedback amplifiers, the bandwidth of the THS6182 is an inversely proportional function of the
value of the feedback resistor. The recommended resistors with a ±12-V power supply for the optimum frequency
response with a 25-
load system is 1 k
for a gain of 5. These should be used as a starting point and once
optimum values are found, 1% tolerance resistors should be used to maintain frequency response character-
istics.
OFFSET VOLTAGE
The output offset voltage, (V
) is the sum of the input offset voltage (V
) and both input bias currents (I
) times
the corresponding gains. The following schematic and formula can be used to calculate the output offset voltage:
VOO
VIO
1
RF
RG
IIB
RS
1
RF
RG
IIB–RF
+
V
I
+
R
G
R
S
R
F
I
IB
V
O
I
IB+
NOISE CALCULATIONS
Noise can cause errors on very small signals. This is especially true for the amplifying small signals. The noise
model for current feedback amplifiers (CFB) is the same as voltage feedback amplifiers (VFB). The only
difference between the two is that the CFB amplifiers generally specify different current noise parameters for
each input while VFB amplifiers usually only specify one noise current parameter. The noise model is shown in
Figure 71
. This model includes all of the noise sources as follows:
e
n
= Amplifier internal voltage noise (nV/
√
Hz)
IN+ = Noninverting current noise (pA/
√
Hz)
IN- = Inverting current noise (pA/
√
Hz)
e
RX
= Thermal voltage noise associated with each resistor (e
RX
= 4 kTR
x
)
THS6182
SLLS544G–SEPTEMBER 2002–REVISED NOVEMBER 2004
APPLICATION INFORMATION (continued)
Consistent with current feedback amplifiers, increasing the gain is best accomplished by changing the gain
resistor, not the feedback resistor. This is because the bandwidth of the amplifier is dominated by the feedback
resistor value and internal dominant-pole capacitor. The ability to control the amplifier gain independently of the
bandwidth constitutes a major advantage of current feedback amplifiers over conventional voltage feedback
amplifiers.
It is important to realize the effects of the feedback resistance on distortion. Increasing the resistance decreases
the loop gain and increases the distortion. It is also important to know that decreasing load impedance increases
total harmonic distortion (THD). Typically, the third order harmonic distortion increases more than the second
order harmonic distortion.
Finally, in a differential configuration as shown in
Figure 1
, it is important to note that there is a differential gain
and a common-mode gain which are different from each other. Differentially, the gain is at 1 + R
F
/R
G
. While
common-mode gain = 1 due to R
G
being connected directly between each amplifier and not to ground. This can
lead to potential problems as the stability of the amplifier is determined by R
. Thus, R
must be large enough to
ensure the common-mode stability, even though a large differential gain may be required.
Figure 70. Output Offset Voltage Model
17
相關PDF資料
PDF描述
THS6182DWRG4 LOW-POWER DISSIPATION ADSL LINE DRIVER
TIED87 REFERENCE DIODE PAIRS
TIED88 REFERENCE DIODE PAIRS
TIED89 REFERENCE DIODE PAIRS
TIG002SS Light-Controlling Strobe Applications
相關代理商/技術參數
參數描述
THS6182DRG4 功能描述:緩沖器和線路驅動器 Low Pwr Dissipation Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel
THS6182DW 功能描述:緩沖器和線路驅動器 Low Pwr Dissipation Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel
THS6182DWEVM 功能描述:其他開發工具 THS6182DW Eval Mod RoHS:否 制造商:Parallax 產品:ELEV-8 Hex Upgrade Kits 類型:Robotics 工具用于評估:ELEV-8 Quadcopter 工作電源電壓:
THS6182DWG4 功能描述:緩沖器和線路驅動器 Low Pwr Dissipation Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel
THS6182DWP 功能描述:緩沖器和線路驅動器 Low Pwr Dissipation Line Driver RoHS:否 制造商:Micrel 輸入線路數量:1 輸出線路數量:2 極性:Non-Inverting 電源電壓-最大:+/- 5.5 V 電源電壓-最小:+/- 2.37 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*