- 您現在的位置：買賣IC網 > PDF目錄383948 > TISP5110H3BJR-S (BOURNS INC) FORWARD-CONDUCTING UNIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS PDF資料下載
參數資料
| 型號： | TISP5110H3BJR-S |
| 廠商： | BOURNS INC |
| 元件分類： | 浪涌電流限制器 |
| 英文描述： | FORWARD-CONDUCTING UNIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| 中文描述： | 110 V, 60 A, SILICON SURGE PROTECTOR, DO-214AA |
| 封裝： | ROHS COMPLIANT, SMB, 2 PIN |
| 文件頁數： | 8/11頁 |
| 文件大?。?/td> | 286K |
| 代理商： | TISP5110H3BJR-S |
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
JANUARY 1998 - REVISED FEBRUARY 2005
Deployment
APPLICATIONS INFORMATION
These devices are two terminal overvoltage protectors. They may be used either singly to limit the voltage between two points (Figure 11) or in
multiples to limit the voltage at several points in a circuit (Figure 12).
In Figure 11, the TISP5xxxH3BJ limits the maximum voltage of the negative supply to -V(BO) and +VF. This configuration can be used for
protecting circuits where the voltage polarity does not reverse in normal operation. In Figure 12, the two TISP5xxxH3BJ protectors, Th4 and
Th5, limit the maximum voltage of the SLIC (Subscriber Line Interface Circuit) outputs to -V(BO) and +VF. Ring and test protection is given by
protectors Th1, Th2 and Th3. Protectors Th1 and Th2 limit the maximum tip and ring wire voltages to the
±
V(BO) of the individual protector.
Protector Th3 limits the maximum voltage between the two conductors to its
±
V(BO) value. If the equipment being protected has all its
vulnerable components connected between the conductors and ground, then protector Th3 is not required.
TISP5xxxH3BJ Overvoltage Protection Series
Figure 12. Line Card SLIC Protection
TEST
RELAY
RING
RELAY
SLIC
RELAY
TEST
EQUIP-
MENT
RING
GENERATOR
S1a
S1b
R1a
R1b
RING
WIRE
TIP
WIRE
Th1
Th2
Th3
SLIC
SLIC
PROTECTION
TISP5xxxH3BJ
RING/TEST
PROTECTION
OVER-
CURRENT
PROTECTION
S2a
S2b
S3a
S3b
V
BAT
AI4XAA
Th4
Th5
AI4XAC
SIGNAL
D.C.
-
R1a
R1b
TISP5xxxH3BJ
Figure 11. Power Supply Protection
相關PDF資料 |
PDF描述 |
|---|---|
| TISP5115H3BJ | FORWARD-CONDUCTING UNIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP5115H3BJR | FORWARD-CONDUCTING UNIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP5115H3BJR-S | FORWARD-CONDUCTING UNIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP5150H3BJR | FORWARD-CONDUCTING UNIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP61089HDM | DUAL FORWARD-CONDUCTING P-GATE THYRISTOR PROGRAMMABLE OVERVOLTAGE PROTECTOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP5115H3BJ | 制造商:Bourns Inc 功能描述:THYRISTOR TVS UNIDIRECTIONAL 115V |
| TISP5115H3BJR | 功能描述:硅對稱二端開關元件 Forward Conducting Unidirectional RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| TISP5115H3BJR-S | 功能描述:硅對稱二端開關元件 Forward Conducting Unidirectional RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| TISP5150H3BJ | 制造商:BOURNS 制造商全稱:Bourns Electronic Solutions 功能描述:FORWARD-CONDUCTING UNIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP5150H3BJR | 功能描述:硅對稱二端開關元件 Forward Conducting Unidirectional RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
發布緊急采購，3分鐘左右您將得到回復。