- 您現在的位置：買賣IC網 > PDF目錄98246 > TLE6363G (INFINEON TECHNOLOGIES AG) DUAL SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO14 PDF資料下載
參數資料
| 型號： | TLE6363G |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 穩壓器 |
| 英文描述： | DUAL SWITCHING CONTROLLER, 115 kHz SWITCHING FREQ-MAX, PDSO14 |
| 封裝： | PLASTIC, DSO-14 |
| 文件頁數： | 5/28頁 |
| 文件大?。?/td> | 765K |
| 代理商： | TLE6363G |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Data Sheet Rev. 1.2
13
2003-06-02
TLE 6363
Watchdog Operation
The watchdog uses one hundred of the oscillator’s clock signal period as a timebase,
defined as the watchdog cycle time
t
CYL.
After power-on, the reset output signal at the RO pin (microcontroller reset) is kept LOW
for the reset delay time
t
RD, i.e. 64 cycles. With the LOW to HIGH transition of the signal
at RO the device starts the closed window time
t
CW = 32 cycles. A trigger signal within
this window is interpreted as a pretrigger failure according to the figures shown below.
After the closed window the open window with the duration
t
OW is started. The open
window lasts at minimum until the trigger process has occurred, at maximum
t
OW is
32 cycles.
A HIGH to LOW transition of the watchdog trigger signal on pin WDI is taken by a trigger.
To avoid wrong triggering due to parasitic glitches two HIGH samples followed by two
LOW samples (sample period
t
CYL) are decoded as a valid trigger. If a trigger signal
appears at the watchdog input pin WDI during the open window or a power up/down
occurs, the watchdog window signal is reset and a new closed window follows.
A reset is generated (RO goes LOW) if there is no trigger pulse during the open window
or if a pretrigger occurs during the closed window. This reset happens after 64 cycles
after the latest valid closed window start time and lasts for further 64 cycles.
The triggering is correct also, if the first three samples (two HIGH one LOW) of the trigger
pulse at pin WDI are inside the closed window and only the fourth sample (the second
LOW sample) is taken in the open window.
In addition to the microcontroller reset signal RO the device generates a system enable
signal at pin SEN. If RO is HIGH the system enable goes active HIGH with the first valid
watchdog trigger pulse at pin WDI. The SEN output goes LOW immediately if a
pretrigger, a missing trigger or a power down reset occurs.
相關PDF資料 |
PDF描述 |
|---|---|
| TLE6365G | SWITCHING REGULATOR, 115 kHz SWITCHING FREQ-MAX, PDSO8 |
| TLE6387GV60 | 1 A SWITCHING CONTROLLER, 430 kHz SWITCHING FREQ-MAX, PDSO14 |
| TLE6389-3GV50 | 2.3 A SWITCHING CONTROLLER, 420 kHz SWITCHING FREQ-MAX, PDSO14 |
| TLE6389G50-1 | SWITCHING CONTROLLER, 420 kHz SWITCHING FREQ-MAX, PDSO14 |
| TLE6389GVT | SWITCHING CONTROLLER, 420 kHz SWITCHING FREQ-MAX, PDSO14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE6365 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| TLE6365_07 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Step Down Voltage Regulator with Reset |
| TLE6365G | 功能描述:DC/DC 開關控制器 DC/DC CONVERTER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| TLE6365GNT | 制造商:Infineon Technologies AG 功能描述:Conv DC-DC Single Step Down 8-Pin DSO T/R |
| TLE6365GXT | 制造商: 功能描述: 制造商:undefined 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。