- 您現在的位置：買賣IC網 > PDF目錄385931 > TLP2601 (Toshiba Corporation) TOSHIBA Photocoupler GaALAs Ired & Photo−IC PDF資料下載
參數資料
| 型號： | TLP2601 |
| 廠商： | Toshiba Corporation |
| 英文描述： | TOSHIBA Photocoupler GaALAs Ired & Photo−IC |
| 文件頁數： | 8/9頁 |
| 文件大?。?/td> | 217K |
| 代理商： | TLP2601 |
TLP2601
2002-09-25
8
Notes
1.
The V
CC
supply voltage to each TLP2601 isolator must be bypassed by a 0.1μF capacitor of larger.This can be
either a ceramic or solid tantalum capacitor with good high frequency characteristic and should be connected
as close aspossible to the package V
CC
and GND pins of each device.
2.
t
pHL
Propagation delay is measured from the 3.75mA level on the low to high transition of the input
current pulse to the 1.5V level on the high to low transition of the output voltage pulse.
3.
t
pLH
Propagation delay is measured from the 3.75mA level on the high to low transition of the input
current pulse to the 1.5V level on the low to high transition of the output voltage pulse.
4.
t
f
Fall time is measured from the 10% to the 90% levels of the high to low transition on the output
pulse.
5.
t
r
Rise time is measured from the 90% to 10% levels of the low to high transition on the output
pulse.
6.
t
EHL
Enable input propagation delay is measured from the 1.5V level on the low to high transition of
the input voltage pulse to the 1.5V level on the high to low transition of the output voltage pulse.
7.
t
ELH
Enable input propagation delay is measured from the 1.5V level on the high to low transition of
the input voltage pulse to the 1.5V level on the low to high transition of the output voltage pulse.
8.
CM
L
The maximum tolerable rate of fall of the common mode voltage to ensure the output will remain
in the low output state (i.e., V
OUT
< 0.8V).
Measured in volts per microsecond (V / μs).
9.
CM
H
The maximum tolerable rate of fall of the common mode voltage to ensure the output will remain
in the high state (i.e., V
OUT
> 2.0V).
Measured in volts per microsecond(V / μs).
Volts/microsecond can be translated to sinusoidal voltages:
V / μs =
Max.
dt
)
CM
(dv
= f
CM
V
CM
(p.p.)
Example:
V
CM
= 318V
pp
when f
CM
= 1MHz using CM
L
and CM
H
= 1000V / μs data sheet specified
minimum.
10.
Device considered a two terminal device: Pins 1, 2, 3 and 4 shorted together, and Pins 5, 6, 7 and
8 shorted together.
11. Enable
No pull up resistor required as the device has an internal pull up resistor.
input
相關PDF資料 |
PDF描述 |
|---|---|
| TLP260J | TOSHIBA Photocoupler GaAs IRED&Photo-triac |
| TLP2630 | Dual Photocoupler (Consisting of A Pair of GaALAs Light emitting Diode and Integrated High Gain,High Speed Photodetector)(雙光電耦合器（含一對GaALAs發光二極管與高增益、高速光電探測器）) |
| TLP2631DS | Dual Photocoupler (Consisting of A Pair of GaALAs Light emitting Diode and Integrated High Gain,High Speed Photodetector)(雙光電耦合器（含一對GaALAs發光二極管與高增益、高速光電探測器）) |
| TLP2631 | ISOLATED LINE RECEIVER SIMPLEX/MULTIPLEX DATA TRANSMISSON |
| TLP270D | TOSHIBA Photocoupler GaAs Ired & Photo−MOS FET / Photo−Transistor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLP2601(F) | 功能描述:高速光耦合器 2500Vrms 10Mbit/s High Speed RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
| TLP2601(LF1,F) | 功能描述:高速光耦合器 IC HI SPEED (10Mbps) RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
| TLP2601(TP1) | 制造商:Toshiba America Electronic Components 功能描述:PHOTOCOUPLER HS LOGOUT 8-SMD |
| TLP2601(TP1,F) | 功能描述:高速光耦合器 IC HI SPEED (10Mbps) RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
| TLP2601_07 | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:Simplex / Multiplex Data Transmission |
發布緊急采購，3分鐘左右您將得到回復。